Viewing all customer Discussions for:

21-174 Roll Guide

Hello I need the slider on the bottom right. Thank You

I need two of these replacement parts

this is the broken cap for bottom track of bifold door. the bottom of the track has screw heads so this cap slides in a ridge within the track to clear the screw heads. it measures 2.2 cm or 7/8 inch. I do not have the brand or name of the bifold door.

I have glass mirror bifold doors that are close to 35 years old. The guide pin part is Acme17-4405. The guide pins work but the guide rollers have disintegrated over time. Will the guide rollers you have work with these? If so, how do you get them in the tracks.

This is the mechanism on the part of the door that slides in a track. The door keeps coming out of the plastic roller. Not sure but perhaps the whole mechanism needs to be replaced?

Customer Service, Please offer suggestions! I need to replace my aging Stanley "17-4405" because the plunger spring is no longer “springy” enough to keep the door elevated. Please advise what you recommend to replace or repair the Stanley 17-4405. Please see these pictures. ... (cont.)

I need assistance with finding the parts in the image.

Missing 1 plastic roller that retractable pin should go into.

This is a Stanley monarch full mirrored bifold door. I'm looking for the top and bottom are the same plastic roller that fits inside the track photograph is of the top. It's in fairly good shape. The bottom one has disintegrated completely away. The plastic part it's about 3/4 of an inch wide by 1/4 ... (cont.)

The bottom track of these doors was accidentally thrown out during a remodel and I need a new one asap. They probably date back to the late 1970s when the house was built. The only brand label I can find on them is ACI Glass Products. The first three photos are of the doors and the last two are of t ... (cont.)

This part is for the front door bottom pin to slide in the track.

Good morning the snugger you suggested does not match mine. Please see the attached pics. spring length is 1.5" plastic carrier is 0.75" one side is open and the other is curved downward thank you for the help!!!

i need the rail track guide, and the spring piece that fits in the track itself and acts as a bumper between the two doors.

I'm reaching out regarding an issue with our sliding door. The door has stopped sliding properly, and I've noticed that the pin at the bottom is no longer moving. I'm unsure whether the entire mechanism needs to be replaced or if there are specific spare parts available to replace just the pin. Plea ... (cont.)

Please identified and recommend appropiate part for my mirror bifold door. Lower track plastic roller that hold pin is broken and door is stucking.

I have bifold mirrored doors manufactured in 1999 by Contractors Wardrobe (CW). The pivot bracket on one side jumps in the track, and the door will not open or close properly. The bottom track appears to have spread. The hardware appears very similar to Stanley hardware - perhaps manufactured by ... (cont.)

Your help center assisted me in ordering the proper corner block that I needed, which was 23-407. But now it looks like I need the glider anchor screw for whatever it's called. I'm attaching photos and hoping you can help me find the replacement part as this is now old and worn.

Hello! The wheel is broken for our closet door. Would you have a replacement?Thanks for your help,Elizabeth

I have a bifold mirrored door from indenpendent mirror co . The door is not functioning correctly and i believe I need to replace these parts but I cant find them . can you help

3" long, upper portion is 1/2"W, 7/8"W when measuring bottom side (wings). The lower track has two grooves or tracks. The track has gotten bent wider over the years and this falls down to the bottom of the track and then the door falls off. Possibly need replacement track and bottom door holder ... (cont.)