Viewing all customer Discussions for:

33-020 #8 x 7/8" Phil Pan SMS Screw SS, Painted

This is a retaining strip on the side of our storm door which holds in the window or screen. There are no manufacturer markings on the door, must have come off. Looking for replacement striping if you can assist. Thank you, Bill

I recently bought a house and the storm door wasn't in the best shape. The door glass was stored in the basement but the retainer strips were missing. The lock set indicates it is a Larson door but the sticker by the hinges doesn't match Larson products. The numbers on the door by the hinge are as ... (cont.)

Door clips To hold the glass in place my door was made by Emco

Need to replace for storm door thx

I need some screen retainer clips to keep the window screens in place. See photos of clip and identifying numbers for window

Looking for replacement for Larson (vinyl ?) retainer strips used to hold storm window or screen in place. 3/8" X 7/8" X 74"

Alliance Vinyl windows extruded vinyl screen clip

I need this glaze or similar!3/4 wide by 7/16 tall

This is a picture of the insert that holds the screen in place. I need replacements. Do you have them?

This goes on our storm door and holds in a full size glass panel or screen depending on the season. Made of a somewhat rigid material.

Screws for coil balance support

Doors were originally purchased from Sears. Over the years, the plastic retainers have broken. Looking to find and buy new long pieces that can be cut to size to fit around entire door.

I have this retainer strip that I would like to replace. I have no idea as to the make of the storm door. I saw this post dated November 29, 2016 and believe it to be the same as I have. At that time you recommended going to storm clip 70-180. The problem is the offset from the door to the windo ... (cont.)

Older metal storm door. At the bottom third there's a metal panel that is retained with these plastic strips. The strip is 1/2" wide but I don't know the thickness, maybe 1/8" or less. There are a couple ridges that help it grip the channel it sits in. Pictures are of the strip pulled from its chann ... (cont.)

Looking to replace the Retainer for my Cole Sewell Storm Door Estate Series. The door is either a 4000 or 4500 model, but I can't tell. The registration number is ES 440389 if that helps. I am hoping the part is the same for both. How can I acquire this part?

We are looking for replacement screen retainer strips for our storm door. I've added pictures of the end of the strip. The strips are 62.5" long and are made of plastic. Do you carry anything similar to this?

I have an Emco storm door with an identifying number of 0016068933. I need the pieces (4) that hold the screen or window in place. The door has either all glass or all screen. I'm guessing the door is around 10 years old & was likely purchased at Lowe's or Home Depot.

I just bought a house that has tilt windows. A lot of the plastic screen "retainers" are cracked. The window screen says Century Windows with numbers 34457 006 bedrooms and 34457 005 kitchen. Do you have anything like these? (I'm not sure if I'm describing them properly so I'm attaching a few pict ... (cont.)

I am looking for 8 plastic clips used to hold a screen in place. I am trying to replace screens in two windows.

I have no MFG part numbers