Viewing all customer Discussions for:

90-313 Deep-set Sash Lock, 2-1/4"

Cam lock IWC 1/3 vent single hung alum window dark brown

Need replacement

I am the Jr Warden (responsible for the care f the buildings and grounds) at the Episcopal Church of the Good Shepherd in Silver City NM. We have some vertical sliding windows which need new sash locks. They are similar to your 90-005 locks with a 2¼" spacing between the mounting screw holes, but w ... (cont.)

I have a vinyl window slider 60" x 48". Unfortunately the lock is broken and I need a replacement. Can you help?

Almost identical to 90-005 metal ones I ordered except original a little thicker with a slightly longer locking tab. The ones I ordered will not lock the window as the tabs are too short. Hope you can help me find the right ones Thanks.

I am looking to replace 14 of my window locks. They are over 26 years old and the push piece is breaking on most of my windows.The measurement from install screw to screw is 2-1/4" and the distance from the install screw to end is 1/2"Let me know if you need more information.Thank you in advance,Car ... (cont.)

The window has these aluminum tracks I can't seem to find locking mechanisms for it, any brand names, etc.

Contains a globe on it. body is 2-1/4" long screw holes are 1/2" on center away from front edge The throw latch itself if 5/8"ish long

Please help me to locate replacement for Milgard Sliding window Sash Lock HSLC25

Do you have a replacement part? Thank ylu

Looking for a dozen of these latches.https://www.dropbox.com/sh/rzu2q67dybi6e3k/AADpZY34SyGKx7E_bWkELzCca?dl=0Perhaps they are 15-20 years old. I was able to find ACE, A-S 9521 on them.They are mounted on aluminum, dual glazed windows, bronze. The fixed frame/section of the window is cut to accept ... (cont.)

I have 2 windows lock are broken,looking for sp2203 M2 for IWC lockers

Hi I need to order replacement parts for this window. The lock was broken and needs to be replaced. Please help.

Hi! Looking for a replacement for this lever.

I need this part 5 pieces please. sp 2302 M 2 please see picture

I need to replace a broken IWC window latch. Photos attached

Hello, I need help identifying this window latch. It's length between screws is 2-1/4.

Hi My IWC window latch has broken and I need a repalcement. Attached are photos, can you advise where I could purchase a new one. Thank you

I need to replace my IWC window locks as well as my tilt latches. The locks have the IWC logo, a product number SP2203 and a patent number DES 432,900. The tilt latches are 3 1/2 inches in length, 7/8 inch in width, are 1/4 inch thick, and the two attachment holes are spaced 2 5/8 inches apart. Any ... (cont.)

can I order 2 of this...