Viewing all customer Discussions for:

90-313 Deep-set Sash Lock, 2-1/4"

The windows are old International Windows, circa 1994.The locks are plastic with a metal plate to help open the windows. The hole spacing is 2 1/4" apart. The "tang" or piece that moves to lock the windows goes into a recess on the other, fixed side. There is no receiver. I've tried locks that are ... (cont.)

Hello - I'm trying the find some replacement window latches (horizontal sliding; some to the right, others to the left . The picture is of the window latch that is on a sliding horizontal window. The window slides to the left (facing the window from inside the house). I took the latch off, and i ... (cont.)

I don't know if I can just get the locking part that is broken. You can see in the picture that the "handle" broke. If not then I need the entire mechanism. The window is made by IWC.

I am in Prescott, Az as well and have this latch that has broken. I would.like to replace it with whatever latch you have that will fit the window. I would also like to get in the brown color if possible

Hello there, I'm looking to replace this lock. Where can I find the parts?

All we have is the photo

I tried the 3/8 latch . And the half inch latch and it's too short

Are these Series: 770 or 795? I need: 10qty SWISCO Series 24" Channel Balance Sash Support System. " ": 11qty window latches that holds window in upright postion. " ": 11qty window locks If you provide me w your email, I'll provide more pics.

These are Imperial Windows with security latches at the base of the track. They are plastic and several have rotted or don't stay snap up to allow the window to slide open. No part number on the latch. Do you carry replacement parts for this safety lock?

Hello, I have attached pictures of the balance springs. I am looking for two 19" balace springs, along with the plastic balance attachments and 2 takeout clips as pictured above. I am also looking for the window lock, shown in the picture, black. Thank you! Jennifer

This goes on a sliding window but I don't know the manufacturer. I think its at least ten years old. The mounting holes are 2 1/4 inch between each hole.

Hello, I need a replacement latch that is like the one pictured but in white. If a replacement is not available, I need guidance on how to change the entire locking mechanism as I cannot locate any screws to remove the lock and the mechanism does not seem to have a cover plate. I would also need to ... (cont.)

Hi would the replacement for this 2 1/4" sash lock be 90-313 part? Or...? Thanks for your help.

A number of sliding window latches on my original 1980s sliders have broken or otherwise failed. The mount on the edge of the window in one of two tracks in the aluminum frame. They pivot o catch a groove in the fixed window section to lock.The latches have a a circular logo with "DG" stamped on the ... (cont.)

First two photos standard vertical window, need new lock assembly Second two photos horizontal slider, need new lock assembly Thanks for your help. Steve, Mesa, AZ

Measurements: 2 1/4 inches hole to hole 2 3/4 inches wide 3/4 inch deep 1 inch deep with tongue out The 90-005 looks like it may fit though the tongue is shaped a little differently and description of lock does not say what the measurement is in depth with the tongue out. This is important or it wil ... (cont.)

Hello I need the black side replacement lock. Is it available?

sp3363

IWC window lock

Good morning,You guys were so awesome helping with my window issue a few months back I figured I should try with another issue I am having with a window at a property in Santa Rosa, CA. It is a broken window lock that has IWC on it. The lock toggle has broken off and I can't open the window. I tried ... (cont.)