Viewing all customer Discussions for:

32-223 Small Side Mount Drawer Slide Pair, 12-3/16"

Hi, No markings hope the pictures can help. Need at least 8 slides. Please call or email if you need more information.

I have two night stands that the drawers don't stay aligned. They are hard to pull out and put back in. Thought if I replace the sliders, it would resolve my problem.It is hard to find replacement sliders or the same type. Hope you have parts I can use. The sliders I have are about 12 inches long a ... (cont.)

I am looking for replacement slides that would work for my dresser. Brackets are slim. One part is installed in groove on draw and then other piece on the dresser itself. Would these slides work? Furniture was made in Italy. 30 years old. Thank you

The side rails are metal bars with holes spaced 10 inches apart. Attached are photos of one of the slides and one of the 8 fasteners which has a rounded head that appears to be about 1/16 inch tall when installed. What do you think? Is this enough information? Thanks, Christina

They are 13 1/2 inches closed 23 3/8 inches open they are an inch wideAnd 3/8 of an inch thick Earl

Hi, I recently need to replace my side mount drawer slides on my storehouse dresser (two of them) and wondered if you carried this item. I have attached photos of course.

I am looking for inside side mount rails for my dresser and nightstand. Please see photos. They measure 1/2"×9 3/4" Can you help?

I'm looking for a side drawer slider that fits into a slot on the side of the drawer which is 5/16" x 1/4". The length is 16 7/8" long

I am looking for a drawer slide for six drawers that is 11" long. I am including a photo of where I would like to install the slides.

I need a 3 pairs of groove mount drawer sliders. They need to be 1" in Width and 12-14" in length

The drawer slide is a side mount and ball bearing. It is approx 17 5/8" long and 9/16" high. The track is about 1/4"wide. The slide sits in a recessed groove on the dresser drawer

Do these slides allow you to remove the draw after installation?

32-223What thread are the two marked holes8x32 doesn't work.Talked with Steve 11-18-2020 about this thanks

Hello, looking for replacements for these drawer slides. I've included photos of the slides that are still intact, and the ones that fell apart.

1. Drawer size 34x18x7.5". Please note, the drawer recesses in, so there is not much room on either side for the slides. 2. The actual dimensions of the slide are presented in the pictures. 3. I believe it is part #32-223, but would prefer a 16" track. Thank you in advance for your help. Monty ... (cont.)

1ft 2" long. .75" length made in Denmark. I need a couple. After opening its 1ft and 9.5". Drawer slider.

hello looking for a 1? H. 16? L 3/4? extension side mount. needs to fit into a drawer that has a grove

Original drawer glides have failed, lost their ball bearings and have bent and warped out of shape. Drawer Depth: 14 3/4 inches. Existing Glide length:14 3/4 inches The existing glides are installed in the door groove such that they extend 2 inches beyond the end of the drawer? One screw is holding ... (cont.)

On a Hooker Furniture Bedroom dresser. Ball bearing slide. 12" in length.

IThey came connected so how do we install them in the drawer and in the inside of the cabinet?