Viewing all customer Discussions for:

32-001 Rear Drawer Track Socket

The part that is broken is plastic from a kitchen drawer connection probably made in the '70s

Need a link to order these drawer sockets to replace the broken ones I have

I Need bathroom drawer guide post replacement pictured. So I can fix me bathroom cabinet drawers.

Hello, I am looking for the part as shown in my photos. Your Rear Drawer Track Socket, Product Code 32-001 is a very close match, however the main difference is the depth measurement. The original Tri Pac part has an inside depth of approximately 14/16". You part is 11/16". I am concerned about ... (cont.)

Similar to socket from cabinet ca. 1975

1.0 open and 1.25 deep. Can you help

Looking for the drawer support for the upper rear drawer shown above. Let me know ow if additional info is needed. Thank you

I am searching for what I believe to be a drawer track back plate. The one in the picture was manufactured by Ronthor NYC. The square is 15/16" to the exterior edge of the square. I suspect the top which screws or staples into the back of the cabinet is another inch but as you can see the plastic ... (cont.)

Can you please help me identify this part? It's a rear socket. The drawer travels down a center rail. I don't see any identifying information on the part. Thx!

The white plastic part has no markings. Six screw holes. The almost square part is 4.3 cm x 4.6 cm. The rectangular slot is about 1.5 cm x 2.3 cm.

This is a 39 year-old rear mount for a drawer slide. It's in a kitchen cabinet and is broken. I can't find this part anywhere. Any help would be appreciated.

looking for a rear drawer slide retainer photos attached

Do you know where we can get another one to replace this it is made of molded plastic and the draw pull sits in it. Has not broken

Hello I am looking for a square drawer socket it's 1" deep approx 1"square.

Looking for this center rail support. It was located at the back of the cabinet to hold center rail. Thank you.

The cabinets I have are at least 40 years old and the drawer guide is broke and was hoping you could help or know where I can get one. Thank You

It is from a kitchen drawer that is over 14 years old. Their are no numbers or markings found on the existing hardware. The guide is on the center of the drawer

I need to find 2 of these brackets and I don't see anything like them when I search. My cabinets are by Thomasville and were installed in 2005 (to give an idea of age). Thank you for any insight you can offer. Katherine

The rear track socket broke off and I have to replace it, does this come about a half inch deeper. Say 1" deep instead of 11/16th. This is a tad short for the part that is in there. William

Mid center bottom Drawer glide pocket, 1 inch square, about 3/4 inch depth, . For kitchen cabinet drawer.