Viewing all customer Discussions for:

32-014 Rear Drawer Track Socket Pair

KV 1284-3

Hi, I'm hoping you can find me a pair of replacement drawer slide sockets based off the measurements on the attached pictures. There's no numbers on the sockets or slides. Thanks, Matt

End socket for cabinet rail

HelloI am Having difficulty finding the replacement bracket from my cabinets that were installed in 1995 it is a euro type the length is 2 1/2 inches and the width is 1 1/4 outside with in 1 1/8 inside width. Do you have this part? Thank you so much for your help.Dina

I have ordered several replacements and not have been the correct size. The issues I've had is they are too narrow for the slide to get into the bracket. There is no markings or any identification on the part. If you could help I would appreciate it.

This is the drawer socket which we need, however, the drawer rails are 1" and will not fit into this 7/8" opening. Any suggestions? Many thanks!

I have replacement 32-014 replacements left when drawers were installed, but am at a loss as to replacing them when the countertop is in place and the drawer is below the countertop. Do you have directions for replacing this item at the rear of the drawer??? HELP, PLEASE and THANK YOU. My camera i ... (cont.)

Is your catalog number 32-014 drawer mounting bracket comparable to Knapp & Vogt number 1805-101wp bracket..

Hi Swisco - Need replacement sockets. 2 sets. They are used in my kitchen. The rail is about 1 inch wide and 1/4 in thick. Thank you, Caesar

This is from an older manufactured home, original equipment. Do you have anything that might work? 3" long 7/8" rail height.

Could you plz tell me the length of product 32-014 n product 32-089?I need a length of 3 inches for them to match up for suspension.thank u for your time

Swisco; I need to make an additional new drawer for a bathroom vanity. The existing drawer slides are marked UNIGRASS 6000. The parts are 20" long. Included are pictures, (Due to size, you will receive two messages) following is a list of hardware I am looking for. Can you help me? A) drawer track ... (cont.)

Hello- This piece holds the bar to the wall for a kitchen drawer. The broken one that I need is on the right side.

The socket is marked Hettich and is about 30 years old. The opening is 1". It is 3" long and the base is 1-1/2" x 2-1/2". The bottom opening is 3/16" and the top opening is 5/16"

I keep finding this bracket/back plate for drawers, but the width of the actual opening for the drawer slide is only 7/8" wide. I actually need one that is 1/14"-1 1/2" wide (it is hard to measure exactly as it is broken. Is this one bigger than the 7/8"? There are no dimensions listed that give ... (cont.)

The metal rail/glide has a "G*" stamped on it. The plastic piece that broke has no markings at all.

I need four Hettich CR face frame sockets. Please look at the photo's and advise. I've measured my face frame socket and it is slightly larger than your 32-014. The inside dimensions are 15/16" (approx. 1 inch) by 3/8". I hope that have one in this size. Thank You

I need a bracket with a 30 mm opening where the slide goes and is 65 mm long

I am actually looking for a drawer socket set like 32-014 that is smaller. Do you sell one or do you know where I can find one that is a smaller size?

Dear Sir / Madame: Attached is a photo of a bottom drawer slide socket, which is damaged, and what I believe is an 18" Liberty drawer slide. Would you carry a pair of replacement sockets that I can use as a replacement? The lip won't old the slide anymore since part of it broke off. Thank you ... (cont.)