Viewing all customer Discussions for:

32-031 Rear Drawer Guide

I'm having trouble figuring out which of your drawer guides would work as a replacement. It has HDW Designer and 350 on it. I understand HDW Designer is no longer in business. Do you have anything that would work?

I have a 5 drawer Chester and need to replace all drawer guides. I can't find these locally. Where can I purchase these? Thank you

I am trying to locate a source for the tan parts shown in the accompanying email. Do the dimensions shown match anything in your inventory? You are about the last source I've contacted on this matter. If I must, I can possibly make a reasonable copy that will support the front sides of the drawer ... (cont.)

These are for wooden center tracks for a dresser

This part is attached to the table. The top slides through the piece

This is for a cabinet drawer. The picture shows the working one.

How do I measure for the size

No marking

I need this part The markings say Ronthor Riess Corp. NYC. R-40-28 Pat no. 3,201,187 This is for a dresser drawer and the part is stapled to the drawer and glides over the track. I saw you have a couple of different parts that look close, but wasn't sure which one it was. The descripti ... (cont.)

Inner guide measurements are 1 1/8 x 5/16. Center tab fits in groove of drawer for alignment, but also provides a base for the wood to slide on.

My broken dresser drawer guide measures 1 inch opening with a height of 11/32. Not sure of the rail size. Would the sliding one that goes one inch to 1 1/2 inch work?

Good morning, We are looking for a Rear drawer guide for 1960 Stanley Roll top Desk file drawer that is 1 1/8" across the bottom. Would you please let me know if you have a rear drawer guide in those dimensions? Pictures are attached. Thank you, -Kathy

I live in a mobile home and was looking at the glides thinking they might work on my drawers? They look very similar and I saw another picture of the same use but you had another number for it how do I get to it to check it out before ordering this one

The base has two middle drawers with guides on the back. The upper drawer nylon? guide piece has broken tabs on the bottom. The best I can tell, It is stamped Ronthor Reiss Corp. part number R-40-?. The vertical height is 1 7/8". The slot dimensions are 1 1/16" wide X 5/16" high. Is this enoug ... (cont.)

Please take a look at these pictures to see if you can determine the part I need. I think I saw it on your site. Thank you.

I need a few of these drawer track kit slides, what size are these? I went to Lowes and tried to match but wasn't the correct ones. Thanks Jason

I'm looking for drawer guides for a homemade bar with wooden track. Top is in two pieces and both slide out to access contents. Having trouble finding guides with 3/8 inch depth for the track as most are 5/16. The old broken guide looks very similar to your 32-031, except the track opening n ... (cont.)

Hi, I have an old tanker desk that has damaged guides. There are no markings on the desk to indicate the manufacturer. I have included a picture of one of the drawers, a picture that shows how the two guides are mounted on the drawers, and a close-up of one of the guides. I'm calling this a t ... (cont.)

The base "fork-like" part says #9429 40MM. The picture shows the handle & base separate. That is because it broke. The intact handle says HTL on the window part. What is the replacement parts I need to order? I also need a draw guide. Do you sell them? A picture is attached as well. I need t ... (cont.)

I need to know which one I need for replacement. I need like 12.