Viewing all customer Discussions for:

39-448 Tie Bar Guide

Part #'s: 40725 and 45139 Hi I need 3 of each of the above Truth part #'s. If you don't sell them, can you recommend suitable replacements? Thanks

My wind out Crestline window will not stay closed (IMG 1802). The plastic pieces holding the sliding metal track have deteriorated (due to the sun and age). I need two different parts. One is the part (IMG 1803) to hold the sliding metal rail that goes up and down when you try to secure the windo ... (cont.)

This part has no identifiable # or name stamped on it; however, the tie bar on casement window is labeled Truth. 2 screws go in the farthest outer holes, which are 2 inches apart. Trying to locate replacement part. Thank you.

We have 15-year-old JELD-WEN casement windows. One window is missing the three tie-bar guides that the other windows have.

My casement window is about 25 years old, this small plastic guide has broken.

this is a crank out lock part if you have it please contact me thank you.Gil

There are 3 of these 'clips' that aid in the bar locking the window. I have one that snapped off and the window doesn't completely close...it's getting cold outside!!

I am in need of some replacement Tie bar clips for my casement windows. I do not know the manufacturer, but the inside of one of the dual panes has this stamped: "WS IGCC - CBA 03/IGMAC WS MED" Which may not be helpful. The attached pictures show the clips, I have ordered part #39-448, and the holes ... (cont.)

This is a piece of plastic that holds the lock system of a true casement window

Your help is much appreciated.

Hello, I am looking for replacement Tie Bar Guide for some casement windows I have. It has a butterfly type guide and is stamped with # 40726 on the guide. I have read through your site but don't see anything quite like the one I'm looking for. The 39-471 is one that you recommended to a lot of ... (cont.)

I'm unable to find out the manufacturer oof my bay windows, I have looked all over for some kinda markings.. I need help finding the bar guide parts. Thank you

27 inch

This plastic piece has failed on most windows in my home. There are generally 3 to each window and they hold and guide the metal bar (mostly vertical but some horizontal) that slides up or down when the window is locked and released. Any help identifying this would Be appreciated. I require 20. T ... (cont.)

I have Jeld wen windows made in 2004. I am looking for the following. 1.vertical metal locking bar as seen in picture 2.The plastic clips that hold the bar in place as seen in picture 3. The hand crank out and bar hardware

I need these parts both right and left

It is 22 and 7/8" long. The metal rod. (Not the whole window) It also appears that the white plastic bracket threat wraps around the rod is also broken. This ig's the good side. The one (Rod)on the other side is completely missingPlease contact me with a price. Warmest regards, Debby ... (cont.)

Hi. I need to replace a Truth 45251 casement window operator with 9.5" arm (40049 stamped on arm). The distance between the outer screw holes is 3". The crank assembly (without arm) is 4" wide, 2.75" deep and 11/16" high. It looks like you have two possible parts that will work: 39-365/366 and 39-02 ... (cont.)

Greetings, The plastic guides for the locking bar on my Weathershield Awning windows have all broken. Two windows with 2 guides on each. Can you help me? The photo shows it laying upside down. Thanks, Joe

My tie bar lock is 29-1/2" long. You show a 30.9" tie bar, but I only have two cone rollers, you have three. My cones are 4 inches from the top and 7-3/8" from the bottom.