Viewing all customer Discussions for:

32-056 11-3/4" Self-Closing Drawer Slide Pair

In need of 22 inch replacement drawer slides. I have not been able to find anything close to these

The plastic going into the wall broke away from the drawer side rail.

Bracket for a side mount drawer guide 2" tall 1.5" wide 3/4" total depth 2 round parts in the back stick out 3/8" past flat back. They are 1/4" in diameter.

I have to figure out how to replace these broken rails (nylon wheel came off completely). I am told these rails are no longer manufactured. Do I have any options to make something work?

I am looking for a rear drawer slide socket (pair). I do not see any markings on the hardware.

Hello, Im in need of a drawer slide socket. I took picture of it with Google & it shows as a 32-002 socket. Would you have any of these? I also attached a picture. I appreciate your reply.

Track wheel is dragging and has flat edge. Need replacement part for it.

Drawer track support plate

Looking for replacement drawer hardware in the sides. The rolling ball has broken off.

This part came of one of my kitchen cabinets its my by Tenn Tex Plastics part C100. They only sell in bulk and commercially so I was unable to purchase from them

The drawer/shelf keeps coming off the glide because the glide is shifting out of position in the rear socket. Is there a fix for this?

Wellborn cabinets from 20ish years ago. Just need the plastic bracket that the rail is held in place by.

A plastic piece that holds the side track of my cabinet door broke. The plastic piece has the marking RSI. It fits onto a fork like piece at the end of the drawer slide, which is marked POW2 R20207 – RCAB. The piece that broke Had two posts on the back that inserted into two holes in the back ... (cont.)

The slide end that mounts to the cabinet front broke off. I included a photo (4413) of it installed. The other photos are of the broken part. It is a rear cabinet dowel mount with the plastic clip. I can't seem to find a replacement for this. It is about 21 inch slide and the drawer is a bottom moun ... (cont.)

I need to know what this is called and where I can purchase a replacement

Im looking for these Drawer parts Rights and Lefts

These nylon/plastic drawer slide hangers connect the metal drawer slides to the back of the cabinet through holes where the two plugs fit into

Photos on some other brackets that I need for my kitchen cabinets

Can not find this anchor for back of cabinet

These rollers have 1/2" plastic wheels with ball bearings and have Grant DL and DR stamped on them. If you have these or an equivalent what is the minimum order for both the right and left sides? Thank you.