Viewing all customer Discussions for:

32-056 11-3/4" Self-Closing Drawer Slide Pair

Only marking is that it's made in China

I'm having trouble identifying the parts shown. I need the rails and the stopper part that attaches to the metal bracket. I'm hoping this picture is clear enough for you all to identify these particular parts.

The Hettich 602 has a wall side upper and lower slots for the support bracket. This feature makes the SWISCO 32-089 Back Plate incompatible with the Hettich 602. The 32-012 is too short (2-1/2"). The Hettich 602 is 3-3/8".

Do you have it in stock?

" ATC JBS08A 10.0mm" is on the inside of the hardware

I'm hoping to add to an existing set of sliding drawers using the same mounting system. It seems like the plastic bracket fits into holes that are similar to adjustable height shelves, but I can't find anything like it. The cabinets say they are "handmade in Oregon" and "inspected in factory #2" but ... (cont.)

The plastic/urethane end of the right drawer bracket cracked into three pieces. I need a replacement part or the entire bracket assembly. Best I can tell the whole assembly number is 00045-51, 6603/582/cl-cr/AI. Stamped into plastic/urethane end bracket Pat# 4930739. I tried to include a picture of ... (cont.)

I can't find this. It's the rear slide mount. The photo is missing one of the plugs that goes into the back of the drawer slides.

Looking for guide that fits ~1 1/8" slide.

Hello. I believe the slides are made by Grass America and might be the Express model. These came with the kitchen cabinets that were installed in our home in 2013. The rear bracket has broken on this one and we're looking for the replacement for these parts. The slide has a 90 degree angle where ... (cont.)

Hello. This piece broke off of the back of the kitchen cabinet. It looks like it needs the two prongs. I've attached one of the brackets which still has the prongs attached.

That green thing holding it was just so that it wouldn't fall. I can't find this anywhere. Where can I buy this rear drawer bracket?

Hi there,From other posts, I'm thinking these plastic clips with pegs are nearly impossible to find. The pegs broke for one drawer, so now the rail won't attach to the back of the cabinet. I'm guessing I'll need to reinforce the back with wood and find a new rail system with screw-in back mounts. An ... (cont.)

I need to replace the actual drawer but the drawer slide and bracket need replacing as well. Can you help find the parts or suggest something similar/better? The bracket is cream/off-white and holds the drawer slide at a 90 degree angle. The bracket has plastic tabs on the back that holds onto the ... (cont.)

We need to replace drawer slides on our 20+ year old Scandinavian-Style dressers. The drawer slides have become misshapen and the bearings have fallen out. They are very slim and about 10" long. You can't remove the drawers without unscrewing to separate. On the drawer, the very back hooks under ... (cont.)

The cabinets were installed in 1992 by the previous owner so I do not know the manufacture. The inside dimensions of the socket are 3/8 by 15/16 and 1 1/4 deep. The exact replacement would of course be best, but if there is one that requires screw mounting with everything else correct then that wo ... (cont.)

need 3 sets. Side mount. The outside metal circular tabs fit into metal frames installed inside the cabinet. Cainets installed 25-30 years ago.

Looking for p/n for a rear press-in drawer slide mount (plastic piece) as seen above in the picture.

I want the rail that your part #32 040 goes in

Hello I am looking for the above brackets used in the kitchen cabinet drawer slide support. Attached are front and back faces of the bracket. Would appreciate if you could assist in finding the same.