Viewing all customer Discussions for:

32-060 19-3/4" Self-Closing Drawer Slide Pair

I was trying to move my cabinet drawer up and tried to remove the mounting brackets and ended up breaking one. Can't get them to budge at all. I can't find a replacement online.

I have this rear mounting bracket in my kitchen cabinets, and they appear to be missing all the screws to keep the sliding supports connected to the drawer. I'm not sure if the screws are actually needed. I am on a quest to find this plastic rear mounting bracket and read its installation instructi ... (cont.)

Hello, I'm in a months long process to replace a failed unigrass 22.5" drawer slide set on one drawer. Cabinet depth is either 22 3/4" or 23 1/2" (see photo). Drawer box is 22" to the back of the faceplate.The challenge has been to find replacement slides that can mount to the drawer box properly. ... (cont.)

I would like to know if you can identify these. Also, If you carry them, Diamond Cabinets installed 2007

Hi there,I'm looking to upgrade the shelves in my pantry to drawers. The two existing drawers have spacers mounting to the slides. Do you have these spacers? I can also use a suggestion on which guides to use as well, the drawers would be 21" deep.Thank you,Tal

I just need to replace the left side

I am unable to find this black sliding drawer rear bracket anywhere. Please suggest thanks

I need to replace this to mount my drawer but cannot find the part

I am relocating my drawer to a different cabinet. How much for a pair of brackets?

Appears the cabinets are Mastercraft. Need the backplate support piece for the slide rail.

Hi! This bracket has wings on both sides, but one is broken in the photo. These sit horizontally. The brackets have no identifiable marks as to manufacturer. It is a single piece. It is about 1 5/8 long by 1 3/8 wide. I need at least 8 of them. Please help. Thank you!

This part hangs the back of a drawer rail ..... The cabinets are made by Merilat and the hardware associated are branded with a "grass" logo or a G* logo. The cabinets were made in the mid to late 1990s. Thanks in advance for your help finding this part

Need this rear slide bracket for pullout cabinet drawer.

Only marking is that it's made in China

Looking for 10 pairs of replacement drawer slides for Blum 513.500.02.05 and 510.500.02.05. They are 2 fixed metal slides with some plastic parts in the slide area. See pix. Just the plastic parts are shot but I will probably need to replace the entire slides if plastic is not available. Plastic pie ... (cont.)

I'm having trouble identifying the parts shown. I need the rails and the stopper part that attaches to the metal bracket. I'm hoping this picture is clear enough for you all to identify these particular parts.

The Hettich 602 has a wall side upper and lower slots for the support bracket. This feature makes the SWISCO 32-089 Back Plate incompatible with the Hettich 602. The 32-012 is too short (2-1/2"). The Hettich 602 is 3-3/8".

Help!!! The bottom rail bent due to the weight of the drawer and I can't find a replacement anywhere...someone recommended your assistance! Please ohhh please can you direct us to the piece. No one around Charleston can help. Let me know if you need any other details. Amanda

Do you have it in stock?

" ATC JBS08A 10.0mm" is on the inside of the hardware