Viewing all customer Discussions for:

32-062 23-5/8" Self-Closing Drawer Slide Pair

Kraftmaid cabinet drawer needs new runners. What do you suggest? 23 inches total with roller on underside drawer. 21 inches on sides of opening.

I need a new pair of these.

I have 3 kitchen cabinets from Kraft maid cabinetry. And the slides are worn.

Hello, I am unable to find a rear backet that will hold up the drawer guide.

Do you have this part or know where I can get it?

Wheel broke off. Need replacement slides

Do you have this part of something that will work? My cabinets are only 6 years old.

In need of 22 inch replacement drawer slides. I have not been able to find anything close to these

Drawer slide 21 5/8" Cabinet bracket 23" mounts into plastic bracket in back of cabinet.

I need to replace self-closing drawer slides to two kitchen cabinet pan drawes. The drawer slides fixed to the drawers are 21-5/8". The drawer slides fixed to the cabinet side are 23-5/8" ? Is that how the pairs of slides come ?

19-04, and I already purchased the 32-04 rail bracket from Swisco

We have the 2 glides attached to each side of the drawer. We need the parts that attach to the interior sides of the cabinet. The glides we have are 22.5 inches.

23 3/4 " 25yr old drawers/cabinets

Looking for these replacement slides and parts 22 3/8

The plastic going into the wall broke away from the drawer side rail.

Bracket for a side mount drawer guide 2" tall 1.5" wide 3/4" total depth 2 round parts in the back stick out 3/8" past flat back. They are 1/4" in diameter.

I want to replace some drawer sliders. They have a bottom edge that the drawer rests on but the screws need to be on the side because the bottom board is not thick enough. How do I decide what length I need? The actual piece of metal on the slider in the picture measures 22 3/8 inches. ... (cont.)

The metal bracket is 23” long by 1” high The plastic bracket holder is 1 1/2” long by 1” high. Thank you.

I have to figure out how to replace these broken rails (nylon wheel came off completely). I am told these rails are no longer manufactured. Do I have any options to make something work?

I am looking for a rear drawer slide socket (pair). I do not see any markings on the hardware.