Viewing all customer Discussions for:

32-062 23-5/8" Self-Closing Drawer Slide Pair

Hello, Im in need of a drawer slide socket. I took picture of it with Google & it shows as a 32-002 socket. Would you have any of these? I also attached a picture. I appreciate your reply.

Track wheel is dragging and has flat edge. Need replacement part for it.

I have the outside rail, but I need the inside rail to fit on the drawer. I'm in Orlando Florida. Do you have any suppliers in this area that carry these parts?

Drawer track support plate

We are looking for bottom part that is attached to the cabinet that roller part that is attached to the drawer slides into.it is 23 1/4" long. The replacement sets have all of the slide pieces at the same length. The lenthos the slide pc on the drawer itself is 21 1/2ish

Looking for replacement drawer hardware in the sides. The rolling ball has broken off.

i need replacement drawer rollers - 12 large ones and 12 small ones. they go in a (45-50 year old) 4 drawer office cabinet made by steelcase (i think). i have included measurements (using a digital caliper) of the rollers. they are similar to SWISCO item # 32-039. however, the item # 32-093 do ... (cont.)

This part came of one of my kitchen cabinets its my by Tenn Tex Plastics part C100. They only sell in bulk and commercially so I was unable to purchase from them

Our home is built by Dr. Horton with Bellview floor plan. The drawer slide bent and need replacement. I bought 22 inch everbuilt bottom mount slide set from Home Depot but the slider that gets fixed inside the cabinets is short

The drawer/shelf keeps coming off the glide because the glide is shifting out of position in the rear socket. Is there a fix for this?

Can you identify this drawer track back plate? I purchased item 32-089 which is very similar, but it's larger. I've included a side by side photo with 32-089. 32-089 is the larger one in the photo. The smaller one has a height of 2", width of 1 1/4" and length of 3 3/4". The inside of the channe ... (cont.)

Wellborn cabinets from 20ish years ago. Just need the plastic bracket that the rail is held in place by.

A plastic piece that holds the side track of my cabinet door broke. The plastic piece has the marking RSI. It fits onto a fork like piece at the end of the drawer slide, which is marked POW2 R20207 – RCAB. The piece that broke Had two posts on the back that inserted into two holes in the back ... (cont.)

The slide end that mounts to the cabinet front broke off. I included a photo (4413) of it installed. The other photos are of the broken part. It is a rear cabinet dowel mount with the plastic clip. I can't seem to find a replacement for this. It is about 21 inch slide and the drawer is a bottom moun ... (cont.)

I need to know what this is called and where I can purchase a replacement

Im looking for these Drawer parts Rights and Lefts

These nylon/plastic drawer slide hangers connect the metal drawer slides to the back of the cabinet through holes where the two plugs fit into

Photos on some other brackets that I need for my kitchen cabinets

Can not find this anchor for back of cabinet

The front of the one rail snap in the cabinet at the front. I am trying to replace the rails for this drawer. it's about 22" long. If I can't what can I replace it with and how do I remove the plastic thing on the cabinet without damaging the cabinet it'self. Is there an embosed part number i ... (cont.)