Viewing all customer Discussions for:

32-062 23-5/8" Self-Closing Drawer Slide Pair

I'm having trouble identifying the parts shown. I need the rails and the stopper part that attaches to the metal bracket. I'm hoping this picture is clear enough for you all to identify these particular parts.

I'd like to replace this Unigrass 6600 pull set. From what I can find the DMR is the 6600/570 and the CMR is the 6600/582. Would you have a direct replacement or a suitable substitute?

I need to replace all the hardware, both slides and guides on both sides.(Terminology?). The drawer mounted hardware (slide?) is 22 1/2 in long and numbers I can make out are 32-02 and 34-??. The cabinet mounted guides are longer at 23 1/2 and numbers are 36-02 and 31-02.

The Hettich 602 has a wall side upper and lower slots for the support bracket. This feature makes the SWISCO 32-089 Back Plate incompatible with the Hettich 602. The 32-012 is too short (2-1/2"). The Hettich 602 is 3-3/8".

565/22.25R 17002-86

Hello,I need four drawer slides for my old st Charles cabinets. They are 24 inches long and have wheels on them.

These are on Mereilat cabinet pots and pans wide drawer that are about 20 years iold. The drawer measures 23 3/4 inches long.

Help!!! The bottom rail bent due to the weight of the drawer and I can't find a replacement anywhere...someone recommended your assistance! Please ohhh please can you direct us to the piece. No one around Charleston can help. Let me know if you need any other details. Amanda

Do you have it in stock?

" ATC JBS08A 10.0mm" is on the inside of the hardware

Looking for this rear socket to replace a missing one for my trash slides.

I'm hoping to add to an existing set of sliding drawers using the same mounting system. It seems like the plastic bracket fits into holes that are similar to adjustable height shelves, but I can't find anything like it. The cabinets say they are "handmade in Oregon" and "inspected in factory #2" but ... (cont.)

The plastic/urethane end of the right drawer bracket cracked into three pieces. I need a replacement part or the entire bracket assembly. Best I can tell the whole assembly number is 00045-51, 6603/582/cl-cr/AI. Stamped into plastic/urethane end bracket Pat# 4930739. I tried to include a picture of ... (cont.)

I have a part number as 2883164 from Merillat Replacement guide con kit base

I can't find this. It's the rear slide mount. The photo is missing one of the plugs that goes into the back of the drawer slides.

Hi, I'm looking for a drawer slide for a 24 inch drawer that goes into a rear drawer socket that is pictured in the upload picture. The back of the drawer slide has a 90 degree bend that slides into the rear drawer socket before mounting the screw in the front of the drawer.

I have a grass slide labeled a unigrass6600. It is of two unequal lengths. The drawer mounted piece is 19 3/4". The piece that is mounted to the cabinet and the rear is 22 7/8". Do you carry a slide like this. Thank you Rich

Looking for guide that fits ~1 1/8" slide.

Good Morning, The Unigrass item I need is shown in the attached photos. Please help me order two of the brackets along with the plastic back wall mount. Thank you very much

Hello. I believe the slides are made by Grass America and might be the Express model. These came with the kitchen cabinets that were installed in our home in 2013. The rear bracket has broken on this one and we're looking for the replacement for these parts. The slide has a 90 degree angle where ... (cont.)