Discussions for Door & Window : SWISCO.com

Replacement Channel Balances

Good morning, Looking for replacement channel balances for the photographed balances. Length of channel measures roughly 31-5/8". Let me know if you need anymore pics Thank you!

+1

Crank window operator

Hello, my window will not close because the internal hardware has been stripped and can not grip itself to crank it close.

+1

Broken window crank

Hi. I have a Jeldwen casement window that is broken where the handle attaches to the crank. I'm not sure which part to order.

Coil balance

Says #9.0 35" stamped on it. Seems like series 195, 196 or 160.

Window lock broken

Pat no 4736972 Truth. I cannot find any locks with the application on the side like this one. They all apply from the top and I have the double hung windows. With the latches that lock from the side.

Window balance identification

Has markings "2650 BSI" Has pulley, spring and cord

+2

Need replacement part

Need replacement for broken spring balance. Marking is "a 16 HD". Measured length is about 16 15/16 inches long. Thanks for your help, Dave

Window latch locking mechanism

The internal part of the mechanism....the part that is inside the window casing, no longer works.

Milgard Vertical Sliding Window Balancer 29 4 HW CMC 7

The balancer has following part number. 29 4 HW CMC 7 I need to purchase the replacement.

+8

Glazing bead

Hi, I'm looking for a replacement part the glazing bead in the pictures. It looks like this but the measuring is off https://www.swisco.com/3-foot-vinyl-glazing-bead/pd/Snap-in-Glazing/55-180Thank you for your help. Uyen

+1

gray swivel pin for sliding glass doors

Looking for gray swivel pin replacement part shown in the pictures, I don't have the manufacturer of the sliding windows.

15 5 balances

Need help identifying the size of my channel balance

Replacement tilt latch

Hello, I'm looking for a left and right replace latch for a alside, 0901 series double hung vinyl replacement windows. I have attached a pitcher of the latch and a picture of the window sticker that I got the info from. Thank you for your help

Looking for this sliding window roller with plastic enclosure

Looking for part. No more additional info

Arc tall plate handleset for a storm door

I'm looking for a lockset with a deadbolt at the top and a lever set at the bottom. The spacing between deadbolt and lockset is 6 inches and the screws are just below the knobs.

+1

Millard window cranks

I have several Milgard windows that are very difficult to move and impossible to close. The house, built in 2003, windows have a tag that gives catalog number and indicate they were built on 11/05/02. Size of this one is 23.5 x 71.5 Do you have a replacement for these? Thanks

Locking mechanism for Pella Patio Screen Doors (vintage 2004)

I am looking for the screen door closure with locking mechanism for double door Pella screen doors. I have attached pictures of both sides and a view of the double doors.I believe the year was 2004 or 2005 when we had these installed. They were purchased through the Cary, NC store representative an ... (cont.)