Viewing all customer Discussions for:

Door & Window

The dimensions are 1 1/8" width and a length of 1 1/16". From what I see online, the

I am trying to identify which number is the part number, and specifications for that part number so that I can order a replacement IGU

Looking for patio screen door slider track

I send these pictures

Believe windows are 10 yrs? The Label under the Frame over the upper window sash says S.O. 10123939.4.1. I BELIEVE they are from Home Depot....maybe 70 PRO SERIES Low-E Argon Glass double hung vinyl. My question....the Pivot Shoes have a BLUE PLASTIC circle that holds in the metal bars on the bott ... (cont.)

1605-6 Crank in set(1603-4) is branded as Pella, but the lock handle does not contain branding. Looking for the lock handle (1605-6).

I am looking for an operator and upper/lower hinges for this window. The operator arm is 9 1/2" from roller to bend before crank. The upper and lower hinges have 10" mounting plates with a 5" swing arm. The hinges are stamped with 385-1 R or 1 L according to location at the top or bottom. I believe ... (cont.)

I actually need all of the replacement parts for the truth casement 40887 The crank and the sash dyad are in working order but need to know what else we need for replacement. I am including pictures Thank you for your help! You have been incredible in the past. Hoping you can help us figure this ou ... (cont.)

These are Sears windows that were installed in the early eighties.All the newer tilt latches have 2 screws these only have one screw.They are 2"long x 1"wide

I need 2 operators with handles and screws

Hi, I need help identifying parts to replace the constant balance double coil in my vinyl windows. I can't remember who made the windows, but I think it's either Simonton or Certainteed or some other manufacturer in Richmond, California that's no longer in business.I took a few pictures of the label ... (cont.)

I need to replace it. I'm clueless about measurements, etc. I had ordered a replacement from Amazon, but when it got here I noticed that it had two holes at the top of it and the one in the picture only has one hole at the top. I had to return it. I'm asking my son to install it since I am in my ... (cont.)

NEED TO REPLACE CRANK FOR A NAMI WINDOW NFRC 100/200 SERIES FDCSMT MST 2040 DO YALL HANDLE THIS PART

Hello, I have a few of these broken, was hoping you could identify what I need to order. I cannot find any part numbers on them. Thanks

I reached out a while back and was talking with Josh - request 36748142. I got around to one window that was not rusted out.

This (worn out) roller is from a sliding glass door on a 1999 Fleetwood mobile home. I've not been able to find a replacement that has the mounting screw on the top and another on end above the adjusting screw. Roller diameter is 1.5 inches. No identifying marks found. Thanks for any help you can pr ... (cont.)

I need a new handle for sliding door.

Good morning, I am looking to see what the part numbers are for the upper and lower rollers for my patio door in Florida. Thank you Dan

Hi Hoping you can help me out here. The screen are for jeld wen double hung windows. Lip construction on screen frames. Image 433 dhows the little retainer used on top part of screen and image 434 is the bottom corners

33 inch, slightly less than 33 as shown in the picture. part number 3240 (RM written to the right) bottom piece has marking PAT 6598264 top piece has marking 3 in front and 16 on back