Viewing all customer Discussions for:

Door & Window

2-3/8 long about 11/16 wide

Looking for a replacement door handle

Hi, Please see attached photos of for casement Jeld-Wen builder series. I need: 1. Case and crank 2. Child safety opening device/limiter

36 inch balance stampes h-3520... also window lift & LOCK HANDLE FIRST IMAGE Thanks John

I am looking to replace Marvin casemaster window cranks from 2003. Will the 39-107FK work on this window? When Marvin still had available they were sold as right hand or left hand

Need parts for 1997 Soft Lite vinyl windows, two seals and two latches.

The edge of these parts are broken on both sides of the frame and possibly jammed. Pivot bars break when trying to pivot the window. Is this repairable? If so what parts are needed,and is there a video for installation? Order history should show pivot bar item #26-226.Thank you.Mike ... (cont.)

The lock for my sliding door broke so I ordered a new one from Swisco, item# 82-265. The lock fit the door and functions properly, but my existing latch doesn't fit the lock and the lock will need stay attached to the latch and comes loose if you put any pressure on the door at all. Can you provide ... (cont.)

I can replace the part myself if you have it. I can also supply more photos of the part Thank you in advance Bruce Frey

I need to build one (1) of these window screens. Normally windows have a receiving channel and the window screen goes into it, but these are the opposite; the window screen has a receiving channel and a piece on the window slides into them. I need the frame and four (4) corners. Color: Almond. ... (cont.)

On the arm that moves the window in and out, says Anderson 7073a under neTh that a R. The locks themselves work fine, anderson7047r. I can open and close the window, just not tightly. And when I go to unlock the window to open it, it's as if the window does not move out a bit when the lock is releas ... (cont.)

I have many of these that look like the pics. Some screws are missing or loose or broke. So do replacement locks like these come with over size screws to fit snug in old hole or probably same size. In either case I could use a few. thanks

Hi. I need two patio door rollers. It's about 2" long x 1" high x 3/8" thick. The wheel is about 1 1/8" across. It had a single screw in the side (not shown in photos) that adjusted the wheel up and down. Thanks in advance for your help. Regards, Ron

All the windows in this house are made by this company SWC and about 50% of this mechanism shown in the picture is broken . Just wondering first of all how to remove the plastic unit and what part number that might be.

Hello! Looking for the best replacement for a couple broken Polaris window tilt bars. They look to be around 2 5/8 long. Thanks!

I have sunrise double hung tilted in windows with two layers of pile weatherstripping that are letting in a lot of breeze and a lot of tiny bugs so I need additional weatherstripping. The thickness seems to be somewhere between 1/8 to 1/16 of an inch and I can't find a product like that and sunrise ... (cont.)

Hello, I have a bow window and the hinges have rusted out top and bottom. The first picture is the top. The 2nd one is the bottom. I measured and the old hinges appear to be 10 inches. The window is from the curb right. I would like to know what exactly I need to order for replacements. Thank you. ... (cont.)

Hi. I'm trying to locate weatherstripping for a window(s). The manufacturer was Oldach. I understand they were based in Colorado and are no longer in business. Do you have this product available or an alternative I could use? Thomas

Crank slips and won't seat back into the operator. Not sure which part is need of replacement (or the whole thing)?

I do not have markings on anything that I can identify on the window. It measures to be 1 1/4 x 9/16