Viewing all customer Discussions for:

Door & Window

I just need the handle to this window. The handle is the only thing I need but I can't find it anywhere. I took a picture of the handle of the window next to it, its the opposite side but it look just like the other handle that broke. Do you guys carry this part? The mechanism of the window works we ... (cont.)

Hello, Could you help me find these thingies? Jay

Hi, i'm in need of replacement spring balances for these windows, and some weatherstripping for the bottom. Any help would be greatly appreciated. Dimensions are 29" wide (pane itself) and 51.5" long. Any tips on repairing this crack at the bottom would also be helpful. Thank you! ... (cont.)

20.5" length metal, 1/2" wide, 5/8" deep. Winged at both ends.

Hi, I have an original, probably late 1960's aluminum window, 34"H x 32"W. It appears not to have any spiral balances at all. Just gone. Can these be replaced? The lower section of the window is 32" W x 18" H. Jana

Need about 17 feet of rubber that slides in aluminum trim on three sides of opening, and 7 feet that slides into actual door above and below mortise lock, and mortise lock cover with weatherstripping and screws on door.

1" wide receptacle that caps ends

Hello I'm looking to change the color of the hardware to Gray from gold on these Milgard casement windows. Also looking to do the same for this French door

I need several Pella double hung window lock keepers. I have the locks, just missing the keepers. 2 1/4 inches in length.

I need these parts (Window lifts and tilt latches )These windows might be Weathershield or Marvin but I don't see a name. The build is 2000 per the label on side of the sash

I need this

Enco forever door serial A 343282 door handle hardware kit

Can you help find this Simonton glazing bead or anything close, Soft leg on bottom

Window won't stay open & from comparing to other windows in The house the piece in the picture is broke. Do you sell the replacement parts?

Hey there! I also need a pivot pin replacement for a single coil balance. One of them fell out and was lost. The tooth is 7/16"

I have a Marvin sliding glass door with a broken lock.... Can you help me with parts to fix the lock?

Looking for a quote of (4) balances.

Window sash are made by CertainTeed Thank you for looking into this

Hi there. I am looking for a few replacement parts for the item shown in the photograph. Can you help me?Regards,Richard

The tag is rubbed off. I can't see the SN but I can see "PGT- sliding glass door- SGD-2500 FBA25.1, FL328". Could be that the B is something else.