Viewing all customer Discussions for:

Door & Window

Hello, I need a few sets of the window latches for some broken ones we have in the house. The Windows are White Vinyl/PVC Capitol 9555 series I believe. The latch is on the bottom part of window and the part the latch goes into is recessed into the top window.

Hello,My 6.0/4.0(6ft wide/4ft tall) sliding window handle needs replacement. The spring inside the handle has rusted thru and is broken. Please advise me if you can provide a replacement.Eric

Please see photos abd advise replacement parts

I need replacement pivot shoes for a Coil balance system, Lincoln window? Thanks much, Jack

I am looking for a casement window handle and operator arm and piece that mounts to the bottom of the window. Right and left opening casement windows (one of each).

It no longer works - cannot open or close the window. Can you identify the part and should we replace it? Thank your

The rollers were replaced 17 years ago we think we got them from Bunnings I have google searched these and I can't find anything. There are no numbers or orher markings. Everything is metal.

I was able to remove 1 of 8 rollers. I took pictures but no measurements. I only get access to the house 5 times a year. So I can't get at the doors for another few weeks. If these pictures are go enough I want to purchase 8 roller sets for the 2 doors.

Would you be able to supply a replacement Ply Gem window latch, per the uploaded pictures? Thanks in advance, Marcio

I need to replace one of my Truth Casement Window Operators. The bottom of my Operator has the number, “45034”. After browsing the SWISCO online catalog, I think a suitable replacement is the “Ellipse Style Single Arm Operator, 9-1/2 Inch”, Product Code: 39-027E with &ldquo ... (cont.)

34" balance length 1/2" width Has wings 1 3/32" balance shoe depth Balance stamp 33 3 BSI 22.6 lbs window weight

I would like to replace the slides, pivot pins and springs on my pace setter windows. Slides are 1.25 in wide, 1.4 in tall, .55 in thick. The only markings on the springs are CL on one and B on the other. The windows weight 20 lbs each. The pins have 9862 stamped on them and are a little over 3 inch ... (cont.)

5/8 inch wide. 1inch tall and 3 and 7/8 inches long.

What is the part number size? What is it? I need six of them right and left help me out. I'm tired of looking.

They are plastic. They are likely to break if I remove them.

See photo for numbers stamped on metal frame. Need you to tell me what lift weight option i should select when ordering. Thanks

I believe this is a milgard window- measuring 30"x50"

Hello, replacing my window balances and not sure which ones mine are.Non tilt, 1"2" wide valances. I need ones that are 25" tall and that are 30" tall (measured end of metal to end of metal).One has a marking of: "24-9 IA2 CMC 6" on it.Also going to need replacement top dash guides, but I believe ... (cont.)

Screws 3 inches apart, one sided handle

Tube is 29" long