Viewing all customer Discussions for:

Door & Window

I need the spring loaded top keeper and the bottom piece that keeps the panel in the frame

I like to get a foldable one to replace it.

Hi, I need to replace this door hardware. There are no names, numbers or markings on it as far as I can tell. The distance between the screw holes is 5.125 inches. The inside handle has broken off. Please advise, and thank you.

im a handyman looking to get replacement parts for a window that will crank open, but wont close without help. included is a picture of a broken portion that appears to have a part number on it. im afraid i only have assembled photos, and they are limited as well. if you need other photos please let ... (cont.)

Please see attached shoe. It measures 1" tall, 1 1/4 wide, 9/16 thickness. I have a possible ID, 15-208, but the height is not 1 1/4....any other shoe? Thanks for all your help. Thanks Beth, Dayton Glass

I didn't understand value

I need 28 1/2 in balances would a 28 work or should I go to a 29 in balance, or do you custom make balances?

No information on existing hardware.

Looking to replace with exact unit

Hello, I need to replace my window coil balancer. can yuo please identify and let me know the part number so that I can order. On the coil it is showing #5 on one of the coil and number 6 on the other one. On the plastic I see #3.

I need help finding this casement mechanism.

can you source these??

I have Wincore 8800 hurricane windows with 48 lb sashes and the plastic clips keep breaking after only about 10-15 cycles. I tried to get parts from Window World and have been working on it since March. The last springs were not assembled as the two tandem springs.Do you sell a tandem housing like ... (cont.)

Only markings on the part are 5. This is out of a vinyl window but I don't know the brand

I want help to find the latch mechanism, but would like to buy new handles as well, so looking for complete set for two patio doors that are both the same. If you need more information please let me know. Thank you! I appreciate your help. Attached is another full picture of the handle and latc ... (cont.)

This lock has a handle broke off of it and on the other side somebody put gray putty on. Hopefully you can identify it & stock it. The distance between the two screws is 1 7/16". Thank you

Hi,its 29" long and 3/8 wide

Written on metal portion is "32 4 EU CMC 2". Please help us identify!

I can't quite determine which series channel balance to select

Hello, I was wondering if you guys have any parts similar to this one - the longest arm I could find listed on your site was short than the arm that I have (roughly 14 3/4" from crank stud to end of arm)