Viewing all customer Discussions for:

Door & Window

Looking for this

I've included dimensions on the first photo.

I have an Anderson sliding glass patio door handle that has broken. Photos with specs are attached.It is a Silver Line 8002344228. The recommended replacement legacy handle 82-086 is 8 1/2" top to bottom not 9 1/2". Thsi should not make any difference if the rest of the mortice and door handle spe ... (cont.)

Please give me the best parts to keep this window up as we open it.

I am hoping you can identify the attached part so I can order an exact replacement if I need to. Attached are three pictures which will show you a comparison of a Swisco Part 81-287 which I purchased from you recently and the actual part that I removed from the patio door. As you can see it it sma ... (cont.)

Hi, I am looking for a balance cover for a MI Window - 19521168.1GA7050Photos are included in the document attached. thank you - Sherie

4 Slider SCREEN Corners needed. It apears they are marked CD-690C-2. Door was manufacured by: Sunshine Windows Manufacuring Co. Hialeab, FL (305) 364-9952 May also need 4 new rollers with spring.

I'm trying to locate some of these for a customer of ours, these are the pictures they sent me. These belong to a aluminum gliding window and acts as a handle / lock when you pull the handle it kind of releases the latch part of it. unsure of the brand, they are approx 50 years old. ... (cont.)

the window lock is 2-7/8x5/8 inches What my maintenance guy found for window info etc is also attached in a pic. any suggestions on what to purchase for maintenance to replace this?

Looking to replace my patio sliding door handle assy. Screws on center are 4" and overall length is 7 1/2 ". Door wall thickness is 1 3/8". My homes windows are all pennco but cannot find any markings on this door . Hope all this helps.

Hi. Can you please identify the part that has to be replaced in these photos? The footings that connect the spirals to the window sash are cracked.

Will this fit my door. This is the original sticker in the jam.

This is a follow-up to your previous request #36779754 "Part number for single roll..." I am pretty sure the measurements are 1 7/8 or 1 15/16 not over 2 inches. And the other measurements seems to be about 1 1/2. Can you check the 81-046 please? Warmest Regards,

I would like to change to a folding crank as we just installed blinds that hit the current cranks. We have a total of 10 windows that we would like to change to the folding crank. Current markings attached in pictures Truth Entry Guard Other number 40887 can you please let me know what we would ... (cont.)

Hi there, the window operator seems broken. It won't close the window anymore, it only works from full opened to a 90% closed, and then the cranking doesn't do anything anymore. Which model do I need ? The arm measures 9 inches. The lenght from top mounting hole to the bottom hole is 5. 25 inches it ... (cont.)

B I U

Hello. The pictures attached is the locak and latch that needs to be replaced. Would you be able to identify or recommend a replacement?

Looking to identifie this tension rod. its 2' long.

Would like to purchase 5 handles with the hardware (pins?) to replace broken ones in my home. The windows are from CRYSTAL

Hi, I need a replacement for the attached screen roller. The measurements are: Metal spring width 11/32 inches, Wheel diameter 1 inch, Wheel width 1/4 inch, Guide pin diameter around 1/8 . It looks like your item 84-084 but it has a guide pin.