Viewing all customer Discussions for:

Door & Window

I need both R and L operators. Imprint in housing is 60063. Please provide finishes available, lead time and cost.

Casing is plastic 34 1/2" long 1/2" dia

Unable to locate new or used latch .... for lock of Patio Sliding Glass Door. Original equipment of resindence built in or around 1983 -1986.

There is a hook where two spring is attached and is under constant tension . The number on these two balance is 6 and 5 on each side of window. Can you send some instructions videos on how to remove and install new complete balances. I need to order asap. Thank you I had previously inquire sbout ... (cont.)

Length: 23" Width: 0.5" Need two of these (will call to ask help in identifying proper replacements)

Need right and left side

This holds the window spiral and the bar that goes from the window into that piece to connect the whole assembly.

Drawer pull KBC20003. 51997

Hello. I need a new arm for the window on the right. I thgink its Truth hardware and the arm is about 8".

Attached are photos of the door lock mechanism which I removed as we could not get in or out of the door. The patio door system consists of 1 stationary door, a center door that swings in with the locking mechanism and a 3rd door that can be unlocked and swing in. The lock system is attached at bo ... (cont.)

Hello, I am looking to order replacement window cranks that fit this spindle. I will provide a picture of the crank and the spindle

The first picture shows the broken swivel. The second shows the unbroken one on the other side. The storm door is over 20 years old and the model info is on the last picture.

I searched your website and did not find any match. Please help to identify the part. thanks

Good afternoon, Do you have this part in stock? I believe the gear is preventing the window from closing. Thank you

I need 2 channel balances with the clip attachment #15-198. I think the series 795 is the one I need. Stamp reads 32B BSI Please let me know the total cost for 2 of them.

This part is easy to fix?

Hello, I need some help identifying and ordering the correct Milgard casement window hinge. As seen from one photo, a part of the lower hinge (the 'crossbar') is missing. The lower part that is mounted to the actual window frame is 10" long, Window is smaller, less than 18"x24" I understand I will n ... (cont.)

Pics of part needed.

I can't remove the old broken shoe.It doesn't slide up and down . I've replaced shoe on Pella windows before. So have a general idea of how it works. I also don't know which part I need to order.

Sliding Glass Paito Door Mortise and Lock Keeper needed for sliding glass door Serirs 1210, SGD-R25Mfr Code A-161-1-3(F or 7) ANSI/AAMA 101-88