Viewing all customer Discussions for:

Door & Window

I have Alside Windows Tilt Windows installed in 2012. I think the model number is 301. I have enclosed pctures of Pivot Bar, Pivot Shoe, and Tllt Latch. The Pivot Bar looks like your part 28-486 (lenght and hole pattern match). I am not sure about the Shoe and Latch (need both directions). Ther ... (cont.)

3/4wide, 6in total length, 4 1/2in on screw holes, total depth 1 1/8in

The plastic tab that holds the cover in broke off. looking for replacement. windows installed in about 2005.

Not sure the brand, but it's what's on the bottom of the sash that snaps into the window frame.

Hi am trying to find replacement parts for Simonton casement windows. One size window is numbered 8482928/16. I need top and bottom arms and the opening mechanism

The whole frame is needed.

What part number to replace this operator?

We're looking for this screen clip. It is from a Peachtree Screen, measures 2 11/16" long and 1/2" wide.

Can't make out the manufacturer stamp on the lock or keeper.

Stamped with # 2440 Top feature similar to part #371 Bottom is different Channel Lenght 25" Thank you...

This is from a window that was built in the 1980's in North Carolina. There is a left on and a right one.

Hello, I need help identifying the correct Tile Shoe to replace the ones that have broken in the slides of the windows. I am not sure if I need to replace the coil as well.

Hi I need 30 of the plastic clips and screws for my existing NAMI windows. Code HII, Series CLCASE, MST: 2650Please send the part number so I can order.thank you Doug

The name on one of the wheels is "kilian". The dimensions of the wheels are 1.25 x .25". The housing is a little over 3"x1×.5". There are two 'latches' that hook into slots under the door frame. The piece above the screw that screws into a hole in the underside is broken off. ... (cont.)

Vynal window latches.

Do you sell a bracket like this? It is similar to your in swing door bracket, item 40-006, only upside down. It would need to have a pin and a c-clip to hold the plunger on it.

I am looking for the part indicated in photo

I am trying to idententify exact part (prod code) I need to order to replace broken part (please see attached photo. I would appriciate your help, Leo F

Good Afternoon, I'd like help with identifying replacement window balances and window sash guide. Happy to provide additional info / measurements as needed. Thank You for your time and help! 1. Window Sash Guide (front, profile & rear). 2. . Window Balance (Stamped: 31 4 GO Caldwell) ... (cont.)

Looking to replace this part