Viewing all customer Discussions for:

Door & Window

on the item i see 28c B.S.I.AND BMI think i see it on your sitesincerelyGennade

Almost all my vinyl windows are missing the pop out wedge that mounts on the upper sash to keep the lower sash from raising higher than a few inches. Seem to be 1" length. White. Daily Windows from years past. They sent me to you.

need both latches and handles, quantity of 3 sets. handle is about 2"-2 and 1/16" center to center of holes. latch is slotted but was using about 1 and 1/16" center to center of hole Thanks!

Need help. Can't locate this part. Need several. Windows have GA on top of locking latch.

Hi there, thanks for posting! The stamped numbers you mentioned will help us narrow down your sash weight range, but we'll need to see a few photos of the top and bottom plastic attachments to determine the balance series. If you can back to us with those, as well as the length of just the metal cha ... (cont.)

I'm trying to replace the side channels for 4 of my single-hung/non-tilt vinyl windows. The side channel is market "27 3 BSI MG". From my estimation, I have a Series 380 or 385. I have attached photos with measurements, as well as the label on the inside of the window.

Looking to add a keyed lock to our sliding door that goes out to our deck. Do I need a whole assembly or can I just add a keyed mortise to the existing assembly. Let me know if you need more info or pictures.

There are no markings or labels anywhere on the pieces or windows that I can read or see. The windows are close to 40 years old they are horizontal and there are four window panels to them. I have nine windows that I need to replace the Cranks for they are all wearing out and in bad shape. Hopeful ... (cont.)

Part was broken off by renters part number on back is OP05-7533-03 09/18/03 Not sure if I just need arm or need the whole part. Thanks for your help in advance Alan

Need replacement latch in center of photo.

one of the pivot pins has broken at the bottom of the window so I need to replace that pin - I think I should buy two to ensure they match

This piece is from the window of a portable building. Can't find anything quite this wide. The face is 3/4".

I need to replace the side balances on a single Hung Winco window from 1997. I need to replace both side balances. The side balance measurement is 27 inches long.

I need to find the repalcement corners for my patio screen door

How can I identify the size and type of spring to order?

Hi... Which part replaces the pictures I uploaded? Need both left and right

I measured the pivot shoe 2"long 1"wide and guess I don't know. The tilt window sash i think is little over a 1/2" and slides in the slot on top of the window free pictures

Jeld Wen windows. It's 28".

Hello! I have a home that was renovated in the early 2000's with replacement windows from Architectural Building Components (I found this out by calling Keystone Corporation who used the manufacturer sticker to find the details). Anyways I have a few issues: - First a sagging upper sash in some w ... (cont.)

Do you carry this window latch for my widow that cranks open? Regards Bill