Viewing all customer Discussions for:

Door & Window

Can you help me find a close match to this type of window lock

Good morning, I need replacement parts for my forever storm door lockset snd interior handle. The keys were lost and interior door handle broken. Cant find the serial number on the door anywhere.

Want to know which channel balance is correct to replace my tilt window channel balance shown in the photo. There are no ends on the balance and there is a hook end on the string. Also the balance measures 29 1/4" but it has 2830 stamped on it. Is your 29" length exactly 29" just the metal part? ... (cont.)

I have 5 Jalousie Windows on my back enclosed 3 season porch. The Window Crank operator on each window does operate properly. It is extremely difficult to open and close the windows, in fact for two of the windows handle that is part of a worm type insert broke loose from the main body of the Window ... (cont.)

Height is 3 3/4", length to the pointy tip 3 7/16" Thanks!

Can you help me find a replacement for the inside of my lock.

I am looking for the plate that the latch attaches to and holds the latch in place in the door. I have attached some photos and sketches. The latch works but is not supported firmly in place now, without the plate. I think the plate looks something like item B in the photo "Sample of part B" and wou ... (cont.)

Hello, I was hoping by the pictures attached you could tell me which balances i need to purchase. There is no engraved numbers just a printed code 16 4 IP Caldwell

I am trying to find replacement flashing for a mobile home window. The slightly curved part snaps in against the glass it self to seal out water, while the back side snaps into the channel of the window frame. Thank you.

Took two of these off a very old sliding glass door. Im looking to geet the right replacement rollers to replace the part in the picss

your no.26-366 looks same and good but short .the one i have is 3 1/4 long no on it 6247 i need 4

I am trying to determine the equivalent number part that I need to replace a channel balance marked 25-5 (photo attached). Also, the other photo shows a hole where there should be a catch (stop?) of some sort. What part do I need to order for that? Thank you so much for your help! ... (cont.)

Please help! Not sure what pivot I should be ordering.

Please help!Thank youJoAnn

I need a sliding patio door latch based on the following information. One piece of the latch has Delta Industrial Systems, Miami inscribed on the back. The second piece of the latch has DNS Industries 11 Outside Pull inscribed on the back. It also has this part number: 45-8403. Also inscribed on ... (cont.)

Can you help me locate the window parts listed below? A right side tilt latch for an Atrium 2500 series single hung aluminum window that measures 36 x 37. The measurements for the tilt latch are:A) Tilt Latch 1/4 inch thick, 1 inch wide, and 3 inches long. The measurement from the center of one sc ... (cont.)

Hope you can help or guide me to obtain the small hinge fastener and clips on the end of the Truth Part # 31858 which connects to the window ledge Thanks in advance for your help

Stamp 28 1/4 3 DJ

Here is pictures of the door handle and the writing in the right hand corner of the glass door. I can?t make out what it says but maybe you can recognize a word or something. I can?t find the replacement handle anywhere and I don?t want to have to put in a new door!!!! I?ve been looking for 2 months ... (cont.)

26 4 BS1 pc