Viewing all customer Discussions for:

Door & Window

this is a 30" caldwell balance. Im just checking to make sure this is a match for your model 351/2930

I beleive I have an S385-36" balance. My stamp reads "35D S37 imp". My sash is impact glass and weighs 36 Lbs. What option should I go with? Do I need a custom balance?

I am trying to identify the attached window latch for my Mastic windows. Any idea?

My Andersen balance says " j3 5p23 576" what part number do I use to replace this?

I have purchased from you previously.... have bought channel balances from you in the past....refer to my orders....maybe that will assist you in determining the correct part.... Bill

I'm looking for 3' of white vinyl door snap in glazing to match the photos.

i need 6 of these stamped with 1820P and the metal part is 18.5 inches could not find ends on the PDF file on the web shawn

Hi I need some help. I have a certainteed sliding door that has a broken lock. Last year I had a keyed lock installed on it and it worked beautifully for about a year. Just recently, the key broke in the lock. I thought I just needed to replace the lock but found that the pin that actually latches b ... (cont.)

Hi. I have an International brand sliding glass door. Currently, the handle on it only allows me to lock and unlock it from the inside. I'm wondering if the handle can be switched out with one that has an internal and external access to locking the door. If so, which handle would that be? Or is ther ... (cont.)

A piece that goes into the spring mechanism and sits on the bottom of the window

Mine must be closer to 3/8. I am attaching a few pictures that might help in determining the best fit. I tried to get a picture of the outer diameter and the diameter of the spring. I am also including a picture of the tip. The cover is made of a thin plastic tube. Thank you so much for all of ... (cont.)

Looking for replacement latches/locks for windows that can be folded down inside to clean the outside window while inside. information from sticker on window Series: 375/380 AAMA/NWWDA 101/ I.S. 2-97 H-R40-48x72 MFR Code: HRW-1. Any help would be appreciated. Thank You!

Only stamp I see is 29 5, is the 29 the length? The 390 above looks to be exact. Thank you!

I have four of these that the sash will not stay up on. The plastic sash pivot piece is broken on two and I cannot find this part. Thanks for your help.

I need a crank handle white to operate casement for exterior window. This handle has a male part that goes into female part as part of casement

Will these wheels work on a Nami Sliding Door 8' high.

I have 2 windows that the balances are broken. 1 small window sash and the other is big. The window balance is 1mm less than 29in long 1/2in wide and 9/16 depth. The small window says 28 3 FS Caldwell, The large says I think because of its scratched off 38 9 ES Caldwell. Both look the same. I ... (cont.)

need replacement caps for channel balance single hung non tilt windows. cap measurements 29/32" x 29/32" square top. length is 1" & 3/16" width is 1/2"

Hello, I am looking for a Pella slider door handle -(we just used rollers we ordered from you- part # 81-098) the center mounting screw holes are 6" 5/8 to 6" 3/4. (our customer bored holes to make larger and am not sure of true measurement) What we need looks like your part # 82-218 but is too smal ... (cont.)

Hello, The attached are photos is broken parts in a fold out window and was wondering if you are able to confirm and provide replacement parts?