Viewing all customer Discussions for:

Door & Window

I need a replacement for the sliding screen door pull pictured above. I have submitted two photos - a front view and an end view

I have attached pics of the channel balances I am trying to replace. Looks to me like they are Viking Window balances with a 19-005 on one end and a 15-002 on the other. I do not see a combination with this option on your website, and want to make sure I order the correct ones. They are for three ... (cont.)

Hello, I was browsing your website for a top sash guide replacement but I couldn't find the item. I was wondering if you carry this. The top surface is about 1-3/16 by 15/16. The height of the sash guide is 1-3/4. It has two screw holes side-by-side. Thanks! Matt

Two clips that stop the window from opening up over about 3 or 4 in.

These rollers look exactly like the ones on my sliding screen doors. I notice that there's a suggestion to replace both sets from the bottom when changing one (which makes sense.) It also suggests that doors usually have two sets on the bottom, but doesn't mention the top. My doors have two on ... (cont.)

Part Number 4014

Need help with balance, thank you.

I do not know manufacturer of windows. I hope you have this part. No markings or stamping s on this part.

I REMOVED ONE OF THE BROOK WINDOW BALANCE FOR AVDERSEN, THE NUMBERS ON IT DOES NOT MATCH ANY OF YOUR NUMBERS THE NUMBER ON MY BALANCE IS C7 6P23 1 74

Window balancer stamped P81 12#27 4-87 Thanks.

In 1984 we replaced all the windows in our house with what I believe to be vinyl clad, wood frame double pane Harvey Windows. A couple of the window latches used to close/lock the windows tightly are broken and need to be replaced. I cannot locate any of the paperwork from our original purchase, s ... (cont.)

Hello, I'm in need of 3 tilt latches for my older Nu sash vinyl windows. These are the specs and a photo. Any help would be greatly appreciated. 1-1/4" long 5/8" wide The prongs are 1/8" wide The gap outside to outside is 1/4" The depth of the prongs are 3/8" Thank you!

I need a cover like the one attached. Please let me know if you still carry these and if not do you have one that will work. Thanks Sherry

I have some mid 1980 peach tree patio screen doors that need the rollers replaced. I've removed all the screws I can find and still cannot get them out. What is the secret or what am I doing wrong? Mike K

what is the purpose of the dust corner? Part Number 26-082

I am looking for a truth crank operator replacement part but the arm that I have is about 11 3/4" and your website shows 7 1/2". Do you have this operator with 11 3/4" arm?

I need to replace a Jordan Window channel balance(2)(Pics 057, 052, 053) Can not read the stamp on them but looks like Caldwell 28311. Also need the cap that goes on the sliding window (Pics 060,061). The window is a 20 yr old Jordan NON TILT vertical slide (up/down) window. It weighs 25 lbs, 34 ... (cont.)

I have Kino windows in my 2001 Redman Mobile Home and need to know what ventilation lock I can use. I want to sleep with the windows open at night a few inches and not have to run. The central air. Please help

I need to replacement wheelsets for Panoview brand door or a number 13042 that can be modified

I am looking for nylon plastic cabinet drawer glides/guides for old Triangle Pacific Kitchen Cabinets with plastic drawers. The plastic drawers ride on these guide/glides and they wear. Attached are photos. I await your response. Thank you. John