Viewing all customer Discussions for:

Door & Window

The only markings I can find is on the casement operator-0P051507

I need to replace that part that is not closing the door but I do not know what to buy Thanks for your help

Looking to purchase new balances for my windows. Mine measure 29 in. Metal to metal and 9/16 thick. Stamp that is on the metal is 28bf.

I need to of these rollers i dont see anymore stamps or id marking except (T 163-5). Its for a sliding patio door. If possible i would like to know any iformation you can obtain from these pics. Thanks,

This is 1 1/4" diameter. It appears to be much like 23-043; however, the tap for the screw is different. The tab on the one we need to replace has broken off.

Just need to purchase 52 balances but I am not sure wich types is the correct one. The hiegth that I have here is 33" end to end of metal window balance. Thank you Roberto

1/2 inch wide 1 1/4 inch high

I believe these are called facial guides. There is a third tab that is in the middle two on the second picture. These parts go on either side of the interior of the window.

Looking for replacement

See photos. Thank you.

I have a broken sash channel balance I need to replace. This from mid-1980s gapco window. What would be a correct part?

Balance stamped It is 2950 BSI -Lenght- 29-14/16". Balance stamped 35 DS 35-Lnght is 36"

24" long 1/2" wide, marked 2330 cj

Hello, I just bought a house with a sliding door that has this hardware. Can you please help me find a replacement?Paul

Hi...had a failure of the rectangular white pieces that sit in the window channel. The picture is a properly functioning part (the old one was discarded unfortunately. Thanks so much!

Need to replace 2

15 1/2 15-2 BSI Unknown manufacture. Windows were installed by builder in 6/2006. I need 12 balances.

23-5/8 23.5

Help find my door latch? I just need a new key since last homeowner didn't leave one

2009 new build, looking for a new handle with the lock mechanism