Viewing all customer Discussions for:

Door & Window

I need to replace the locking mechanism in my sliding patio door. Hope the photos help you to identify what I need to order.

I need a replacement for the inside of the door lock. Hoping the pictures attached will help and let me know what I need to order

Need pivot shoes and piece that inserts into it plus new spring and balance charging tool. Thanks.

My balance has the model number as 3420 on it. Do you have ?

Hi there, I am upgrading my crossbow balance with a channel balance. Can you help me to check the pivot bar? I purchased the 26-021 however, on further inspection, I am not sure if the current bar (photo) here can be separate from the metal edges. Any guidance appreciated, Kim

I don't know what this part is called that allows me to open the window only a little so as not to allow the window to be pushed up higher, but normally fits flush with the window case

5/8 wide Tan or Clay color

My name is MikeI'm looking for the hardware picture aboveThank you for your time

Pella Architect series Traditional double hung . Balance marking 34D BSITK

Hi, missing the cap to the base as you can see on the photo with the white hardware. I also uploaded a picture of another window that has the cap on it.

will this sweep fit on a aluminart door ? /

Markings are stamped 16-2 IP5 CMC 85 Lawson single hung non tilt window

My drywall installer sprayed texture all over these, then broke them while trying to scrape them clean. I need 4 replacements.

I need some replacement tilt latches. The ones I've ordered from Amazon don't work. On the back it reads Pat #5.139.291, do you have these?

Chanel is 24" long 5/8 " wide 1/2" deep Numbers stamped on Chanel : 24B. B51

Hello. My house was built in 2007. I need all 4 new handles please. Both right and left side doors. The right side door when standing inside my home has the locking mechanisms. The inside of the handed has the following information,Top of the handles says. 2265, US patent 5125703. Below the locking ... (cont.)

Broken mounting bracket on casement window arm

Crank 39-146 and 39-147

I need 2 replacement Tie Bar Guides. Would part # 39-417 be what I need. My current Tie Bar is 1/2 x 1/16 . Thank you Sharon.

I need to replace the roller for an exterior sliding glass door. Just want to make sure I am ordering the correct part!