Viewing all customer Discussions for:

Door & Window

Good morning, . Please custom made two 34" length x 9/16" x 5/8" steel housing with your 19- 005 top, 15-005 shoe. The old balance stamp is 33DS 43.Which channel balance can replace stamp 33DS 43 non tilt? S390-34 3365 seems not that strong.

Hello all, I am looking for the plastic or nylon piece with the hook that pulls the window in. It is the top piece in the picture. Thank you very much for your time. -Steve

By season-all Patent # 3,449,862 D209.812-D213.676 Need 3

Hi! I seem to need a new thumb latch and the part that goes on the side as well.

Hi, The little piece of white plastic has broken. Now the slides von Unigrass 6000 do not hold together. The length of the slide ist 35 cm. Let me know how to repair. Best SERGE

Hi I'm looking to replace the pull tabs on my window screens.They are an inch long and they sit underneath the spline. Do you sell something similar ? I sent a few pictures.

The window is an Andersen, 400 series, Woodwright Dbl Hung window. The windows were installed back in 2003. The problem is that the cord portion of the balancer is breaking in several windows. The cord gets stuck in the pulley and breaks. On the Andersen website, I can't find the balancer's number ... (cont.)

Hello, can you try and find these parts for me please!

I would like to order two replacement channel balances. Please see attached photos, which are labeled as top or bottom of the balance. If you need more information, please let me know.

I'm looking to replace two pocket door roller mounts from a door that looks to have been made in the mid 1960's. I've found lots online, but they seem to be smaller; and not ball bearing. The current nylon / plastic wheel diameter is 15/16." Wheels are about 1 7/8" from each other. Each bracket mo ... (cont.)

Looking for Anderson sliding glass door lock mechanism. Struggling to find the parts online.

It seems like the gear inside is stripped. When I crank I don't feel any resistance and window doesn't open nor close.

I have a Andersen Fullview storm door serial number 0027602059 The plastic side retainers broke when removing the screen.I need new retainers to be able to put the glass in for winterI purchased the window from Home depot,Maple Grove,mn 5/13/2024

I think this is the correct part just verifying Pivot Shoe, 3/8" Thick Product Code: 15-045

Hi there, I am looking for window balancer in photo. Can you help me. Thank you

I can't find the black slider piece. It has Truth stamped on the arm. The black piece slides in between what looks like (2) c's facing each other

23-9 JX CMC 7 29-9 this balance also has a PL imprinted on it I did enclose pictures to help out. If you need more information please contact me. PGT Windows, about 20 years old

Hello,I was referred to you by Mo Winslow at Harvey Windows and Doors. I'm looking for replacement parts for a storm door latch (bronze as shown in the photos). The spring inside the door latch isn't working, so the door doesn't latch when closed. I have 3 of these storm doors and all of them have t ... (cont.)

Have a few broken top sash guides ..it measures 1 in across top and 1/2 in across narrow part where holes are and is roughly 1&5/8 long please advise on which part to order

5in arm. I can't find any markings on the crank itself. The part that goes against the window is around 5 1/4in.