Viewing all customer Discussions for:

Closet

We are looking for a bottom track for a 24" Stanley mirrored bifold door. Any help would be appreciated.I am looking for a replacement bottom track for a Stanley bifold mirrored door. It is a 24" closet door. I think the part number(which I have been told has probably changed)was BF30-01-24. Do you ... (cont.)

I have a broken roller on my large bedroom glass sliding doors. I took it off the track and found the broken roller on the bottom of the door, there was a screw on the side of the door that adjusts the wheel. . I took the screw off thinking it would release the wheel so I could replace it , but that ... (cont.)

Hello, my name is Ruben, I need some help identifying this part. It is from a sliding glass closet door in a bedroom. One of rollers in the top have broken off. Thank you in advance!

Challenged to find this specific replacement part for my mirrored closet doors. Thanks for any help!

looking for the black plastic part on top of the door.

I need to replace the existing track of my sliding door. The width is 2 & 5/16 inches. The regular track available in home Depot & Lowes are only 2 inches wide. What is the width of 23-501?

I am trying to help someone with even less tech-knowledge than myself to order 4 replacement closet door rollers. look forward to hearing from you soon. If you respond via email, please use the same subject as above so I know it is not junk mail.Thank you,Tony

We have 2 sliding closet door. Top roller is busted and looks like your 23-027.in your dimension picture....you do not have the measurement from the left lower hole to the end. on mine the CENTER o the hole to the bottom is 1 - 1/4". Is it possible to measure yours and see if that matches?Do you thi ... (cont.)

I HAVE A NEED FOR A FLUSH (NO OFFSET) ROLLER BRACKET (?) WITH CUTOUTS FOR FLATHEAD SCREWS. I HAVE A KENNATRACK SET ON ANOTHER DOOR SET THAT HAS THE FLUSH ROLLER. THE REAR DOOR ROLLER SET SHOULD PUT THE INSIDE DOOR AS FAR AWAY FROM THE FRONT DOOR AS FEASIBLE. THANKS

We just sent back the ones we ordered from you. They were too big. Product code was 23-064.

Hello, I tried to find this roller but couldn?t, would you please direct me? Thank you so much! Kornelius

Closet slide on top

How do I remove closet doors that carry these pins. My washer dryer cannot fit with the doors on the closet

I need the top pivot which stabilizes the door . The pivot guide pin is OK.Enclosed is a pic.Hopefully this will clarify .

Markings on the hardware COX 21-717 21-767 21-718 Thank you

We bought an old house....it has sliding metal doors....hardware is shot.

No special markings really.

Hello,It's hard to be 100% sure, but your track looks a lot like our 23-241 60" and 23-242 72" track. Take a look at the dimensions and detailed images on our product page and see if you agree. Thank you!

Hello. I am in need of a bottom track and adjusting post for front edge of bifold mirror door. This is a 30" Monarch door circa 1985-1986.

Our door roller is brocken. As far as I can tell it's DSH 20121. Is it discontinued? With what can we replace it? Thanks