Viewing all customer Discussions for:

Closet

Do you have replacement part for this nylon threaded sleeve, or must I purchase a new pivot? Thank you.

MY CLOSET DOORS ARE 1 1/4 THICK the rollers on top rub inside door, is there any made for thicker door? or have u had luck with any and also a track.doors are 1 1/4 " thick what track kit would u use? and rollers

Hello, I need the rubber parts that keep the doors in the tracks. Here are pictures of my door hardware. Please tell me what to order. Also, here is a picture of the green label on the inside of the doors.

Grant Rocket 3/4 Front 1-3/8 Rear Grant Rocket 1-3/8 Front 3/4 Rear

Dear Sir or Madam, I have just moved into a new home and am missing a door handle to a steel and mirror bi-fold door I have identified to be one that other people have discussed on your sight. There should be two handles, but only one is left and the seller knew nothing about where it went. Cou ... (cont.)

Where can I get replacements? Lowes and Home Depot does not carry them.

its from a sliding mirrored closet doors.Not a whole lot of info other than the markings seen in the photo.

I need to replace the attached closet door hardware. Leigh and Monarch 5/16" track aluminum Bottom track .... total missing , 3-6/0 , 29-5/0 , 13- 4/0 , 9- 2/6 , 40- 1/6

do you sell replacement tracks for the Benchmark brand of Bi-Fold Steel Doors? They use the Product Code: 21-044 style pin. In addition to the track, I also need the plastic pin grommet/guide which snaps into the door and the pin goes through. I have multiple sizes of the door, this particular on ... (cont.)

This part came off an bi-fold door with a metal frame. It is mirrored. The bushing appears to be missing and allowing the pin to wobble and of course, fall out of the pin holder on the bottom of the floor.

I have 1 broken panel (glass cracked, panel frame bent). My hardware is fine as are the other 2 panels and track... I would like to just buy a new panel and reuse my same rollers or with new rollers... anything that will allow me to get a new panel in without replacing the entire system. Anyone know ... (cont.)

This is the top rail for a sliding bypass mirror closet door in an RV. It fits your 23-027 roller hanger. The doors hang off the rollers, with a floor guide. The rollers are 7/8" diameter, with a 1 1/2" spacing. Need a new 6 foot top rail. thank you John T

I need help getting a replacement bracket for my closet door. I can't seem to find the right part anywhere.

I need to remove the closet door how do you unhook the wheels from the bottom track?

Hello, in need of replacement guide see photo

The offset is either 7/8 or 1". Can't find any with this big of an offset. Let me know if you have anything like this.

Can you identify the part number for this type wheel? I don't actually need the whole assembly since the wheel bracket can be removed. Thanks.

We are trying to find a pair of replacements for the part shown. "Scottie Kennatrack" is imprinted on the side of the roller. The closet doors may be original to the house, which was built in the mid-1960s.

This is for a mirror closet door.

I have a US Plywood metal bifold door and I need replacement pin caps. The pin is 5/16" in diameter and therefore requires a cap with a 5/16" inner diameter. Do you have any images of the pin without the cap, or the underside of the cap? Is this pin entirely 5/16", or is it a smaller diameter u ... (cont.)