Viewing all customer Discussions for:

Closet

Thank you for your help

Need to replace eight bottom rollers and two tracks (5 feet each). The purchase and installation was from a store no longer in business. Any help would be appreciated.

We want to replace the bottom tracks on the sliding mirror doors at two closets. We need a 48 inch and a 72 inch piece. The doors were installed in 1990. It appears your product codes 23-242 and 23-240 are similar. I need to confirm that the bottom rollers are convex. I believe they are. There are n ... (cont.)

Stanley 00-5024 Patent pending. Diego

Hi, I need this part which should match up with Product Code: 21-065. Please let me know if you can find this part. Thanks! Travis

The wheel has broken on one of the sliding mirror doors in my bedroom. I'm looking to replace the mechanism. The marking OOX with numbers 21-717 and 21-767 appear on the mechanism, as you can see from pictures, which is approximately 4" high at its tallest and 3" wide. The wheel itself is approximat ... (cont.)

3 5/8 * 72 length and width of track. gap between two tracks is 1 5/8 the glass is made by stanley i need to know if the 23-242 is the correct track attached are images of bottom track, lower and upper wheels.

I have rear closet door roller and the size length is 1-3/8" and the rollers size is 3/4 ".I want know can I go with a different size rear closet door roller like the one u have shown #23-010, Andrew C.

Hi, How do I adjust the dial so that my closet door will sit straight against the door jam? Thank you.

I have a closet mirror door using CW part #RM-G1005. I am wondering they have a part # for right corner and left corner of closet mirror guide or they are the same. I need whole set of this closet door guide. Can you let me know what part # I should order? And how to install this closet door guide i ... (cont.)

Looking for 6 foot replacement track for mirror closet doors

one of the wheels stopped rolling and I need to replace it. I prefer to replace both of them. There is a sticker on the door from Charmac, Inc as the manufacturer of the sliding wardrobe mirror door

Hi - I am looking for a roller assembly like your 23-064, but I need to know if the concave wheel is 5/16" wide. The only number I found is on the actual wheel - it says Toronto Canada 9360. Thank you for your assistance. Margaret Estenes

I am sending photos of my Cox roller 21-767. Do you have these parts? Can you ship four of these rollers to Buenos Aires?

recently purchased your bifold door pin cap item 21-100, but discovered that although the outside dimensions of the cap lined up perfectly with the caps that needed to replaced, the original rods are larger - they are 5/16". Do you have another product that would be usable.

Please help. We have 2 mirror sliding g doors. Total width together is 60inches. We only have one wheel and no track. Can you help?

Seem I have an odd sized door. House was built in 1959 The rolls appear to have a 3/4' offset and flat wheels. House was built in 1959. Thanks again

I have a set of sliding doors in a bedroom closet. The rear door of the set has good roller hardware. The front door of the set has no hardware, as it has broken throughout the years. The rear door hardware measures as the following hardware, found on your site. 23-186 Rear Closet Door Hanger, 1 ... (cont.)

Can I order 8 of these, and how much would that cost?

This track has rusted out. It is 60" as there are two bifolds.