Viewing all customer Discussions for:

Closet

Mirrored closet door roller no longer runs smoothly. The metal frame of the roller housing is scraping against the track. Even though the roller unit is securely fastened to the door frame, the roller unit wobbles and sits at a slight angle (no longer aligned vertically with the door). The top part ... (cont.)

Hello, I have the panel closets that use part 23-017. One of my door profiles got bent and I haven't been able to get it straightened out well enough to securely hold the panel and haven't been able to find replacements. Would it be at all possible to point me in the right direction to find the do ... (cont.)

Hi there, the top pin of my metal bifold door how come out and I need a replacement. Can you assist?

Track insert for safety backed mirror door Ansiz97-1-1984 Cgsb12-5-m86 type c

I don't have any markings on the parts. I have hired a contractor who is doing a remodeling project. We have not seen any railings that might fit these doors. The doors have concave runners (IMG_0481). I'm wondering if you have a 72" track that these wheels will work on? If these rollers don't work ... (cont.)

Upper closet door rollers acme brand

Is the bottom track made of steel or nylon?

I am sending the picture of the track and also the wheels. I have not opened the closet door to remove wheels. It looks like concave track, where the wheels run over the track. My house was constructed during 1984 and it was put at that time. Can you suggest what product i should use to replace it ... (cont.)

Looking to update the hardware for my old metal closet door. I have tried to use WD 40 and other lubricants to try to get the door sliding more cleanly, but I ultimately think all of the hardware could use replacing. I cannot seem to find hardware like this anywhere I look though. Help identifying i ... (cont.)

Recently purchased a home built in 1998. There are sliding mirrored bypass closet doors in the master bath. The bottom track is rusted and unsightly. Not sure just how to remove the doors from the track. Both upper and lower hardware bear the same number: DSH 20121, but the upper hardware has the ro ... (cont.)

Our Master bedroom has COX by-pass sliding mirror closet doors. The span of the entrance is 90 inches. Each panel is 48 & 3/4 inches. The white floor track is bent and scratched. The rollers are concave (21-717 stamped on the mechanism) and are chipped. They do not ride properly in the track. T ... (cont.)

The pictures are the sliding part of the doors, There is no rollers. Need a part that can replace the one in the pictures. It swivels back and forth, want to replace all 4 of them with a part that has rollers. The piece that screws to the door frame it is #6. Please advise as to what part you may ... (cont.)

I have a right and left bi-fold doors need new hardware I have the top rail but need replacement parts any idea who made these the originals are about 28 years old

Look for Stanley sliding closet top door glideThis is the label on backside of door thanks

Does the 23-222B come in sets or as one piece

Looking for a replacement for these. I believe the original is discontinued.

29-708 29 UP

Is this part offered in a bright zinc finish still? Thank you.

Looking for replacement nylon roller for a mirror bifold closet door. Pictures of a roller/pivot cap attached along with the end of the track. Can't find anything online with these dimensions. Doors / hardware have no manufacturer info on them:( Thank you, Pete

Need 4 of these and 4 that have 1/2" offset