Viewing all customer Discussions for:

Drawer & Cabinet

Only numbers I can find 090-2. 1-1/4 Aristocraft

This part is smaller than my rail "C" What part number do I need for a one inch rail? Thank you, Norm

What is this drawer pull made of? Are the handles and the two end pieces made of the same material? Pictured is my drawer pull. It is 4 1/2" center to center. Is it the same as your 22-201?

My name is Rodger I bought the whole dresser and there is six drawers are so two handles on every door if you have any other questions you can contact me I would like to get this dresser looking nice again

They are all broken I can not find them

Do these slides allow you to remove the draw after installation?

Looking for a replacement for this plastic piece that holds the slide rail for a kitchen drawer. Well born cabinetry. Thank you!!

One on each side stationed on chest where drawer sits or slides. about the size of a quarter and 1/16" thick with a tack or nail glued or made within. Thanks for any info

NO MARKINGS, NO NUMBERS ETC. DO YOU KNOW WHERE I CAN BUYS THESE?

I need a new plastic drawer guide. I find these really hard to figure out what size to order due to how they are measured. I measure the inside area that slides over the metal piece and I can't find one that fits. I work on furniture so this isn't my first rodeo. :) I have every size there is, exc ... (cont.)

Please tell me if you sell these ??? Thank you so much.

Almost all of these are broken on my bedroom furniture, I would like to replace them. Thank you Kathy

Do you have any with 3"center,and 3.5" center?

Hi, I bought the Cluthe Drawer Guides to replace our old ones, but they are just slightly not wide enough. We have very old from the 80s drawer guides labelled Hardware Designers Inc., USA with a number on them. Photo is attached. They are sort of falling apart and the plastic is rubbing off too. T ... (cont.)

This is a bracket to hold the drawer on to the slider in a dresser. Can you find me one that fits. Thanks.

Hello. I'm wondering if you could recommend a piece that might work? I have Upload a picture of a working one and then one with the piece missing On the back of the drawer underneath

One of mine broke need replacement R;4028. 201187

Model number is 698.254.53.00. I need it for a right opening cabinet.

It looks like your part 32-351 is what I need but I'm not sure about the dimensions noted. My broken piece is 2 9/16 inches tall and 1 5/16 inches wide and about 1/2 inch deep. That's for one half of the complete hinge.

Hello, I am looking for a replacement drawer slide for an Office Depot Magellan desk I have. The measurements are 13 3/4" closed, fully extended it is almost 31". It is 1/2" deep and 1 1/2" wide. Can you guide me in the right direction? Thanks for your time. Charlie