Viewing all customer Discussions for:

Drawer & Cabinet

This is attached to the back of the cabinet and the metal bar goes into one of the sides of this If you need more info please don't hesitate to ask

Back of cabinet to secure drawer slide.

Hello: We want to replace all this old hardware, but I think we will have to replace it with the same style. It all is stamped GRANT. The first picture are the drawer slides from inner pull out shelves in a cabinet. They are 22" long (we need 8 pairs). The second picture are drawers and they ar ... (cont.)

Part says "G" and "1099"

I need a set of new slided for my draw, but I am not a cabinet expert and need some help identifying what type of slides I need to order. Perhaps I could send you some photos if my description is not that good. The back is held in place with a plastic mount and the rails measure I think 22 7/16 bu ... (cont.)

I need 2 different types of drawer rail brackets to fix some drawers.

Looking for something to replace this breaking off. House built in 1991.

Slot is 1 1/8 inches wide by 1/4 inch deep Only marking is a letter G on the right leg

I can't find this drawer rear anchor #KV 284-3 located on back of the part of this means anything Thank you for your help

I have Brammer Cherry kitchen cabinets from the '90s. I have a corner unit in which one of the concealed hinges has failed. It joins 2 panels with close in an 'L' fashion. Picture enclosed. Can you help me? Thx!

Hi! I think the kitchen cabinets in my home are original to the house that was built in the 1960s. I haven't been able to find replacement guides on Amazon so when I found the manufacturer label in the back of one of my kitchen drawers, I contacted them to see if they still had this part available ... (cont.)

Do you have anything that would match up to this. Exterior of slide is about 15/16"

I need 2 sets of these roller slides

Greetings and thanks for looking at this part for me. I have other pics if needed. Since these parts are almost 20 years old, I think it would be best to replace both the right and left brackets. Also I want to get 3 pairs total - to have for future needs. Thank you. Most Sincerely, Brenda ... (cont.)

i would like to fined a new lazy susan for a corner base cabinet. we want to keep the cabinet if possible do sell just the part or do i need to buy a new one.

Hi, I am looking for Kitchen Cabinet door hinges. Attaching pictures. I need for two doors i.e 4 hinges. Artistrocraft O9C-3 1 1/4

Swinging pull broke. Looking for replacement. Can you help?

I have a Yorktowne kitchen cabinet (~25 years old) which has five drawers withUNIGRASS 6600 drawer glides installed (side-mounted). Recently, one of the plastic rear support fittings failed (probably fatigue fracture). The drawers are 20 inches long. The stationary glide is 22.5 inches long.In my we ... (cont.)

This piece goes in the side of the cabinet. Then the plastic drawer glides between square/rectangle part and divider part (dividing the top larger cylinder looking piece).

Looking for 10 of these hinges - I'm not sure if they are sold as one part or if there are two pieces??