Viewing all customer Discussions for:

Drawer & Cabinet

3"long, has a partial wrap, overlays, resembles a 270 degree hinge.

Hello, We had an accident and one of the front brackets holding a sliding cabinet drawer up was broken. I cannot find the exact same part in the website. Can you help me? Thank you

These photos are of glide and brackets installed, not uninstalled as suggested. I can see no identifying information on them. The particular drawer I'm looking at has outside dimensions 16-5/8" x 21". Brackets are 3" tall, 1-3/16" deep and mount on a 1-1/4" hole pattern. There is 17" between the ... (cont.)

A checkmark or a V inside the "cup" that fits into the door.

I am looking for replacement wheels for my desk drawers. Some of them got lost when it was moved from office at work to my office at home.The smaller wheel is 3/4" dia. X .330" wide x 9/32" dia. hole.The larger wheel is 1" dia. X .325" wide X 9/32" dia. hole.They both have a rubber o-ring as shown i ... (cont.)

Has a pat.# 3613151 and an A in a different area of the hinge We were told these were old european hinges and hard to find. We need 18

What replacement piece will for best?

15-177? If yes, do you have instructions on how to replace? The coil is still working and is a struggle to deal with.

It looks like a europein style hinge I hope you can help me with this thanks again

I have Drexel heritage bedroom set I have an armoire and the right side all the hinge caps came off all I need is to replace them . They measure 1/4 x 1/4

Spring loaded lock

The 3rd picture shows the broken plastic guide.

mounting plate on Grass hinge 1203 has broken - can it be replaced?

Hello, Looking for some Mepla hinges (346.290.70.04) or just the base. Do you sell a replacement for my hinge? What ever happened to Mepla? Thanks, Jerry

Do you know if this is the correct fit for Stanley made furniture ? Thanks !

These look like what is on my current drawers but I need them to be about 17 inches long (430 mm) do you have any that length?

I need to repalce 3 Rear Mounting Brackets for a PMI-CM565R Drawer slide. The dimension of the drawer slide and bracket recepticle is 7/8". I have been to several Hardware and Big Box stores and although their brackets list a dimension of 7/8" they were all to small, approximately 13/16". Can you ... (cont.)

Any idea what to replace these with? the glide support fits into a slot and then that fits into a support using 2 plugs and the support is screwed into the wood from the side.

Trying to find a replacement for my plastic rear drawer glides (picture enclosed) used by the former Gothic furniture company. Their glide has the name Reiss Mfgr Co, R26 on it. I believe I found the right glide on your site (32-030). Would you be able to confirm that? The wood track appears to ... (cont.)

I need to replace the side rails for three drawers from a Scandinavian Design six-drawer bedroom dresser purchased about 20 years ago. Your part 32-223 seems to be a fit. The current rail has similar dimensions (12 and 1/4 inches long, 3/8 inches deep, 5/8 inches wide). Enclosed are photos of a c ... (cont.)