Viewing all customer Discussions for:

Drawer & Cabinet

The picture I have attached is the right drawer socket, but I need both right and left drawer sockets. Our cabinets are Wellborn and I have 7 companies and at this point had no success. I'm really hoping that y'all can help! Thank you in advance for your assistance!Bridget

Under mount rear guide socket for draw needed

Used for the rear socket of a kitchen island slide drawer. About 1 inch hole for the socket. Only marking I can find is "3808" on the inside. I saw some postings about your 32-119 but that won't work because I can't drill into the back of the cabinet as it's for a kitchen island and would drill r ... (cont.)

Saw clips on your website but didn't find any that have a 1/2" offset like ours have. Do you have any suggestions? Thank you.

picture is left side drawer track and I have broken plastic holder...need both sides plastic holder. Part mounts against the rear of the cabinet and holds the track... has number 931.000.36.0050 on it. Just shy of 4" in length

I need to replace a small plastic snap joiner for a front panel on a Pearl jetted tub. I searched their parts website but couldn't find it. It's approximately 1 ½ " x ½ " x ½ ".

Furniture info: Progressive Furniture Inc; Chest Model # P604-14; Ser #:1309P604140020; Mfg Date 10/13 I need either the guide portion that fits on the back of the drawer, or to keep it simple, the whole slide assembly, because I also have a slide with the end 'retainer" piece cracked. The name o ... (cont.)

Need to replace right and left side back wall mounting plates for kitchen drawers

FGV italy

Looking to replace cracked plastic end peice, only marking on slides is unigrass

Hello, I am looking for a replacement part (or similar that will suffice) for a Knape & Vogt 1300 drawer slide, 22 inch, side mount. It is for a drawer on a workbench that my father made 30+ years ago. Do you have a suggestion for me? Thanks, April

hi: I don't find the right piece. The dimensions are in mm. 0.5 mm from point to point. Could I get such a piece. Thanks in advance. if you had this in the warehouse, I would need 10 of them.

I bought the incorrect part. I bought 2 of part number 32-076. I need the rear drawer guide, i think the part number is

The first two photos show the piece that gets inserted into the drawer. The white hard plastic piece on the end has broken off on a few of the drawers, resulting in the drawer tipping forward when pulled out pass a few inches. I'd prefer to get 12 inches and would love 16. Are these old parts stil ... (cont.)

Once installed drawer will not stay on track upon closing back drops down

Need to replace the boot guide. If it's the right one will by at least four.

This is a bracket that can be found at the end of a drawer. It serves to hold the drawer in position. I would need a right bracket and a left bracket. Thank you!

what is the material of this guide? Is it soft enough to put a staple thru it like nylon or will it crack?

Just looking for a bottom drawer slide mount set where the rails are 23 inches long like this one

Hello- I have cabinet hinges that i am trying to replace. Painting the cabinets--but would like to replace hinges PAT 3391420 US PAT 1967 CAN is this hinge made? in other colors?