Viewing all customer Discussions for:

Drawer & Cabinet

Can you help me finding this guide. Everything is the same except the rise spot where the screw goes threw.

No name or number on socket. It is adjustable left to right. I think the closest you may have to it is the 32-119. The measurement at the opening are the same. This one actually plugs into two holes in the cabinet back wall. If there is another part number that might work I have no problem order ... (cont.)

Hello, I have a couple of plastic rear track mounting brackets that broke and I am looking for possible replacement parts. These plug into holes into the thin back plane of my bathroom counter, so trying to drill into them in not a good option. Any thoughts? Thanks!

Hello bought a tvilum dresser off amazon 2 of the actually need the drawers sliders replaced because they are super cheap and keep breaking the slides measure 13 inch x 5/8 × 1/4 deepWould need no plastic bearing holder don't want them to just keep breaking thanks

Hi I was hoping to find 5 of these brackets. I've found one one on your site I think matches it. The brackets are for my bathroom vanity drawers. They are installed an the back of the drawers and slide onto a rail to guide the drawers in an out. I ordered the ones I thought were correct but wante ... (cont.)

Looking for replacement drawer rail brackets for a diamond cabinets Calhoun vanity

The plastic piece tgst stops drawer from falling out

SLIDER GUIDE PART (PLASTIC) for wood drawer

Looking for merillat rear bracket mounts for slides for kitchen drawer. Number inside part is 471037 Thank you

The marking on the hinge is 698.248.59.00 and it is a Mepla hinge. We ordered the replacement 32-349, but it is a different format. I can send an email with the 2 lined up on the cabinet. Thanks in advance for your helpCarol

The picture I have attached is the right drawer socket, but I need both right and left drawer sockets. Our cabinets are Wellborn and I have 7 companies and at this point had no success. I'm really hoping that y'all can help! Thank you in advance for your assistance!Bridget

Under mount rear guide socket for draw needed

Used for the rear socket of a kitchen island slide drawer. About 1 inch hole for the socket. Only marking I can find is "3808" on the inside. I saw some postings about your 32-119 but that won't work because I can't drill into the back of the cabinet as it's for a kitchen island and would drill r ... (cont.)

Saw clips on your website but didn't find any that have a 1/2" offset like ours have. Do you have any suggestions? Thank you.

picture is left side drawer track and I have broken plastic holder...need both sides plastic holder. Part mounts against the rear of the cabinet and holds the track... has number 931.000.36.0050 on it. Just shy of 4" in length

I need to replace a small plastic snap joiner for a front panel on a Pearl jetted tub. I searched their parts website but couldn't find it. It's approximately 1 ½ " x ½ " x ½ ".

Furniture info: Progressive Furniture Inc; Chest Model # P604-14; Ser #:1309P604140020; Mfg Date 10/13 I need either the guide portion that fits on the back of the drawer, or to keep it simple, the whole slide assembly, because I also have a slide with the end 'retainer" piece cracked. The name o ... (cont.)

Need to replace right and left side back wall mounting plates for kitchen drawers

FGV italy

Looking to replace cracked plastic end peice, only marking on slides is unigrass