Viewing all customer Discussions for:

Drawer & Cabinet

I need replacement pairs of Heartland cabinet drawer slide supports. These attach in the back of the cabinet at the right and left sides of each drawer. They are about 2 3/16" long and the opening for the drawer slide roller is about 15/16." I need several pairs as the plastic at the bottom of th ... (cont.)

Had these, but now having hard time to find replacement. Please help! Need 4 pairs ASAP.

Trying to locate item or replacement

Ronthor Reiss Inc. Rear Drawer GlideI have a piece of Baker furniture that has a silver storage drawer on which the rear drawer glide that holds the drawer from falling out broke. The two bottom "C" shaped pieces that grip the glide both broke as they are plastic. The part number listed is R-40-28 ... (cont.)

These are the parts I have removed. Both hinges for the door to door and the door to cabinet. I've already purchased a set but they do not fit in the prestige's holes. Hoping you have another option for me. Let me know if you need more pics, I chose what I think is the best for the 5 pic limit. Than ... (cont.)

Looking for plastic glides for my kitchen cabinets. There 25 years old and I just need the glides can you help?

NEED REPLACEMENT FOR CABINET DOOR HINGE, FOR SOME REASON IT HAS BECOME DISCONNECTED. THANK YOU FOR ANY ADVICE.

I am trying to locate a source for the tan parts shown in the accompanying email. Do the dimensions shown match anything in your inventory? You are about the last source I've contacted on this matter. If I must, I can possibly make a reasonable copy that will support the front sides of the drawer ... (cont.)

I have very old Merillat kitchen cupboards. The drawer mount (see photo) has broken. It is quite similar to 32-012, but not the same, as there are no screws -- rather, it "plugs" into two holes in the back wall of the cabinet. Can I use 32-012, or do you have the part I need?

This part is at the end of the drawer have a part number 1800310

Rear beacket replacement for 20" center under mount drawer slide.Need either 8 brackets like picture or full replacement slides, side wheels, center wheels etc. looks like rear bracket is nylon or plastic.

I need to know the measurement for the flat part of the hinge that hooks on the door. There are three holes I am trying to line up with existing holes. The measurement I am getting is 7/8" center to center. Will hinge 32-101 line up? Thank you.

I need this back support for the right side. Do you make this?

What exactly does self closing mean

Looking for this exact part.

I?m looking to replace a broken piece from a kitchen drawer. See attached photo.

The cabinet drawers are made by QualityCabinets. They told me to contact you. I'm looking for the plastic piece. Specifically the spring like one that grasps on to the tracking. It has collapsed and will no longer hold the track on one side of the drawer. Thanks!

This is the bracket mount for a drawer in my kitchen island. There were 2 tabs on the back that just sit in some holes at the back of the island. No markings or letters other than CR on the bracket slide. The tabs broke off of the bracket, could not find a replacement at home depot. Thanks in advanc ... (cont.)

Need a part number for this L bracket R side

I was glad to find your site. I am attempting to fix 4 drawers for my wife's dresser. The center rails are 17' long Are there some brackets you sell that will help me do that? Regards, Pete