Viewing all customer Discussions for:

Drawer & Cabinet

Please advise if you have this part available. Thank you.

The drawer rear sockets keep breaking , that we buy. First of all, what makes them break? We need a replacement that is at least 3 3/4" long. The other measurements are the same as I bought. The first image is before installing. The second image is what it looks like after it breaks. These are Hicko ... (cont.)

80.850-E Blum hinges

Wellborn cabinet, ~1991, right side of drawer, rear rail support. Looks like crack developed at end of mounting slot, allowing bracket to rotate, causing retaining lip to break off. Need replacement mounting bracket ... Thanks!

Having trouble locating this part it is from my pantry slid out shelve I think the cabinet name is Quality Cabinets but not sure.

center guide socket, inside square measures 3/4" by 3/4" and depth is 13/16" what can you find? I see a rear mount fixed socket part #32-146 that may work if I trim the depth Was hoping to find something like #32-001 that has a 3/4" opening. Thanks Look forward to your reply Steve ... (cont.)

Is there a replacement for the shelf slider cap in the photo? Thanks.

Hi, I'm trying to replace these old grass 6600 slides. I believe they are the extended length 23'' ones, and they end in an L shape which then slides into the socket on the back of the cabinet. I need replacement sockets as well. Any help would be much appreciated! Thanks!Alison

Purchased 1962-63, when moving my mom from one apt in assisted living to another one pull was accidentally broken off. Thank you, Kathryn

We would like to replace the rear drawer sockets but see that they are plugs and not sure how to remove them without tearing up the back of the cabinet. Can you offer a solution? Thank you!

Hello, I am looking to replace my kitchen cabinet hinges, they are probably about 30 yrs old. Mepla 511.243.01.92 Do you have these in stock? Do you know if they still make them? If not, any idea on a replacement hinge I can use? Thank you, David

I am having trouble finding this part. I ordered from your company a similar product but it is 3/4? too long compared to the one I need.

My dresser is from the early 80's. It was part of the furniture that was use on the movie "ET". the dresser has 3 large drawers on the bottom and 2 smaller drawers on the top with a small door to the right of the smaller drawers. The small drawer has a latch to hold the door shut but it is broken. W ... (cont.)

Need plastic rear bracket for stanley lexington dresser drawer assembly

the plastic angle piece that is used to fasten the drawer front to the drawer box.

These are my brackets with 32-119 on the rear. The bracket would not go in but I shaved some plastic off inside the 32-119 with my Dremel bit that cuts sideways. Not hard to do. (Carefully take small amounts off and try on for size as you go.) Then I added another wood piece for screws to attac ... (cont.)

HERES WHAT I NEED 38TOTAL IN BRUSH NICKEL AND SCREWS.

the bracket has the following written on it. p.x. Ind 34 Patented W Handover MA Is this the one you pictured as the 32-299 for 3/4" shelf bracket

Do you know what Blum latch model part number this is? Thank you!