Viewing all customer Discussions for:

Drawer & Cabinet

I'm going to use 4 clip assemblies on each of my false fronts. I've never done this before, and would like to hear any suggestions you may have to make this job easier. Which part is best to attach first, the part for the panel or the one that goes in the opening? Any tips for perfect alignment, or ... (cont.)

I have Cardell cabinets and the drawer brackets keep breaking. Some of it's my fault some is probably poor design or material. They are stamped G6600 R/L. Do you have any of these? Thanks.

Can you find me this rail? I need enough for four drawers each side.

Looking to replace the drawer stops on the china cabinet. It is a curved plastic piece about 1/4" thick. I mounts on the side of the drawer guide.

Hello, I would like a few replacement Mepla hinges that would fit the hinge in the attached photos. I will also send, in a note immediately following this, two more photos that this form wouldn't let me attach. All the relevant numbers are visible in the photos attached and in the two photos to ... (cont.)

The socket is marked Hettich and is about 30 years old. The opening is 1". It is 3" long and the base is 1-1/2" x 2-1/2". The bottom opening is 3/16" and the top opening is 5/16"

Hello, I need some replacement drawer glides for a 1980's child craft bureau. The part # on it is 857233 R-6 and it looks like it was made by Reiss. I have replaced them in the past. This might be a replacement, not the original. Thanks.

Pennsylvania House dresser drawer end.

I need to replace this right-sided broken mounting bracket for my Heartland kitchen drawer from about 1990. Overall dimensions are 2 1/4 x 2 1/4 x 1 1/4 inches. The slot measures 15/16 x 3/8 inch. Thanks for your help!

Help me locate this replacement for brackets of my track shelves of cabinet.

hello, need to replace this part "L1"

At least twenty years ago we bought some Haas kitchen cabinets. They knew there was a problem with the connector pieces breaking. They had sent some replacement parts. They have now all broken except for the one in the picture. I understand that those parts are discontinued. Is 32-119 the proper rep ... (cont.)

Hi, I bought 6 32-122 cluthe drawer guide 1-3/16" x 5/16" They are too big and I cannot use. Are there slightly smaller ones I can swap them for? Thanks Stephanie

Will this hinge work for my application. Doors have a 3/8" overlay and 3/8" inset. Cabinets are faceframe 3/4". Looking for a hinge that is concealed. Thanks.

I need to replace some back bearings that are marked Ronthor Reis corp. NYC. They appear very close in design and dimensions to your #32-118. Please confirm this what I need. Bill Durland

No markings. It's on a desk at my home for a cabinet door.

The parts have no markings. They are for the rear mount on a silverware drawer in which the bars/sliders are under mounted on the drawer. I am looking for any material really to replace these mounts, plastic (I would reinforce) or metal. Hopefully you would able to get the inserts (3/8" long) on ... (cont.)

I need to replace this track on both sides of this drawer. the roller is 7/8in and the length is 22in. what would u suggest I use

How hard or rubbery are these bumpers? Are they plastic, or rubber? Thanks

I just ordered this as a replacement for a dresser drawer. How do you remove the interior piece from the exterior slide for mounting on both sides?