Viewing all customer Discussions for:

Drawer & Cabinet

You were referred by Davis Kitchens in Tuscon, AZ. They did the original installation which was an on-site cabinet conversion to roller drawers. The part I need is the plastic bracket which attaches the roller guide to the back of the cabinet. The roller guide slides into the attached bracket. Th ... (cont.)

attaches the wood slide to the front of the drawer

In moving furniture, movers apparently simply pulled drawers out of frame and in the process apparently pulled out the drawer stops. Stops appear to have been pieces of plastic pushed into drawer tracks.Drawers now fall out when pulled open. Any tips for replacement or repair?

I am trying to find a brace for a railing in a chest of drawers. I have attached a photo below. Any assistance would be appreciated

Do you stock a replacement rear socket for a kitchen cabinet drawer like the one shown in the attachments (front and back)? I would call it a "pop-in" socket because it pops into a metal bracket mounted (riveted) to the back of the kitchen cabinet, rather than screwing into the back of the cabinet ... (cont.)

Do you have anything that would fit this track for a backing plate? At the point of just bring the cabinet to the ground.

Hi, I am looking for a Drawer Roller, it has a nylon 5/8'' roller wheel, it is flat on rolling surface, w/little bearings. thanks, Joe

Hafele hinge.

I would like to see if any parts for my cabinets. My name is oscar

The base has two middle drawers with guides on the back. The upper drawer nylon? guide piece has broken tabs on the bottom. The best I can tell, It is stamped Ronthor Reiss Corp. part number R-40-?. The vertical height is 1 7/8". The slot dimensions are 1 1/16" wide X 5/16" high. Is this enoug ... (cont.)

Need 3 replacement drawer pulls in this batwing style for a Vaughan Bassett highboy dresser. The number on the back is B1347

Good morning, I sent you pictures of my hinges needed. Here they are. It's the lazy Susan bifold door. I placed an order for 32-346 previously and they were not the correct ones. Thank you

I bought dresser at garage sale and five drawers just flop out when pulled out. The center t shaped track is there but no continuous guide. I tried replacing the guide alone but it's still jiggly. Any part I can buy that will act as a track for drawer? 18 inch depth

Hello, Do you carry drawer slide rollers with the threaded axle that are 1", outside diameter? I see that you have 1-1/8". Thank you, Nancy

Which rear bracket would be the best fit? Cabinets are from 1988, but 2-3 of the brackets​ are broken, they hold the runner(?). Thank you. Della A.

Please let me know if you have something that would look like this glide. Thanks,

The tallest dimension is 2 1/4" (part of hinge connected to the door that moves (opens and closes) The widest dimension (width of hinge, both parts) is 2 3/4" The dimensions of the hinge part that does not move is 1" wide and 1 1/4" high (the part not on the door that opens and closes but on ... (cont.)

I have 3 sets of patio doors with two point locks. Now my house insurers state they want 3 point locks....can I change or convert the locks oram I looking at new patio doors? Help much appreciated

The photo will show this hinge with name GROSS on it. It's a face frame style.

Hi, I got an old wooden dresser with wood center "rail" that needed new back brackets. I took off the very old plastic ones that were on the drawer and need to replace them with new ones. The opening on the drawer is 1 inch cross and the rail inside the dresser is 15/16 inches across and 3/32 ... (cont.)