Viewing all customer Discussions for:

Drawer & Cabinet

Photos are attached with some sense of the size. Could not figure out how to find dimensions on the parts in your catalog. Please help. Thanks. Best regards, Chuck

There is a code # on the hinge which is 652.320.65.00 The closest I could find which you sell was 32-349. Mine has 3 adjustment screws however. If I cant locate the exact match, do you have another that would work. thanks

I bought 16 of your 32-345 wrap-around hinge, but now it's not quite fitting. What do you have that would do the job?

The pictured drawer guide is from an American Drew night stand. There are no numbers to be found

Hello, Need to replace the wheel or entire right side of kitchen cabinet drawer. This drawer has metal left and right sides with the drawer slide built in vs wood construction with euro slide attached. Wheel is 3/4" diameter, 3/16" wide. Thanks.

Looking for hinge or replacement you may be able to enlarge to see number

Left and right drawer slide bracket. Where do I find replacements?

Can the 32-053 drawer guide be cut to fit the existing drawer and if so, how much can be cut off?

only number I see is NO3613151 US the other is Apac These are 26 yr old Homecrest cabinets I don't know how to put a pic on here

i am looking for a rear support for a center slide. It is 1 3/4" wide

Mepla 346.290 54/00 Hinge plate has broken in half (photo). I would like to order two replacement plates please. Thank you, Ryan

I am having difficulty finding these hinges

I keep finding this bracket/back plate for drawers, but the width of the actual opening for the drawer slide is only 7/8" wide. I actually need one that is 1/14"-1 1/2" wide (it is hard to measure exactly as it is broken. Is this one bigger than the 7/8"? There are no dimensions listed that give ... (cont.)

This a dilligham sprit dresser. The L shaped side sliders are braking and one is missing. The top part fits into the groove that acts as a teack. It is made of plastic and can't find it anywhere. The bottom part measures about 7/8

Can you help me find the rear sucker parts please.

I need a replacement for my corner cabinet hinge. Part says: 41 M Made in Germany 502.205 76.03

What is the diameter of the ball catch? and also the strike plate what is length and width?

They are 1/2" thick. The gap is 1 1/4" wide

Is this still available. New part #???