Viewing all customer Discussions for:

Drawer & Cabinet

Patent 2857233

I have a customer who needs a few drawers repaired. They have the older monorail system drawer track roller set up like your 32-040 and 32-041. As far as I can tell all I need is the replacement rear mount drawer sockets. I actually do not want the original type rear brackets; I want something th ... (cont.)

I need a plastic rear mounting bracket for a kitchen drawer slide. the drawer has a single track slide, with wheel attached to the back of drawer and simple rollers at front of drawer opening. the only identifier is pat pend. number on metal track and that is 3.352.617. If that exact part is not ava ... (cont.)

One side of our top cabinet drawer has broke. Need to replace. I order 32-012 but it is 3/8" to 1/2" too long. Also, the back side of the broken piece looks to be glued to cabinet back, not screwed in. Any ideas how to take the old piece off when replacing with new?

Looking to purchase a dozen of theses parts.

I need to replace several rear mount brackets - the bracket is stamped 6600 with number '8' and 'G'. I have been desperately trying to locate this particular bracket because the opening is a little larger than most of the other ones. Hope you have them. Thanks for your help. r

Kitchen drawer rear center plastic guide, manufacturer unknown, circa 1980, see photos

I went on the internet in search of these little plastic 3/4

This hinge is about 17 years old. These were used to close the gap between two cabinet doors. The adjustment was maxed out and weaken and finally broke. I went back to the cabinet installer but no luck despite knowing the mfg and the patten number. I could use at least one of these and as many as po ... (cont.)

Please help can't find anywhere

There are no markings of any kind. Drawers and this small bracket are plastic, probably 30 years old if I had to guess. The surface of the bracket where the runner rests appears to be approximately 1/5" wide. It sticks out from the wall about 1/2". There's a matching one on the other side of each dr ... (cont.)

Gold handlefor a older dresser. The middle of the gold handle that you hold to open the drawer. Do u have one I can order

what is the measurement of the opening of 32-018 drawer socket

This is teflon and the drawer rides on it It has a nail impregnated in it

I am looking for a plastic glass retaining clip that is 1 inch long and has a 5/16 inch offset can you recommend one

dresser with grooves in the drawer. sliders are hard plastic with a small round wheel in the middle and the front end 9 1/2" long, 9/16" wide 3/8" deep with 3 screws. on back there are 3 sets of numbers: 2. 31.0810 DBGM Dresser has five drawers and all slides are broken.

Hello I am looking for replacement Rollers for the Drawers in my Steel Office Desk. They are actually a Plastic or Nylon Roller bearing that is riveted into the drawer into a hole on the rear sides of the drawer on both the left and right side. They fall out after time from the holes they are rivete ... (cont.)

Center screw mount- looks like it broke in half. Which part should I order. This bracket is clover shaped (slightly) 1 1/16,square and 7/8 deep.

Hi, I am looking for something to replace this part. I have 8 drawers so I need 16 total. Do you have something that could work?

the hinge fits onto the frame and is self closer.