Viewing all customer Discussions for:

Drawer & Cabinet

I have a Rev-A-Shelf 5349 kitchen trash pullout unit. The slide rails have black plastic pieces screwed to the tops of the rails. They have a hole for the screw and a little plastic pin sticking out to hold them straight. Do you have anything that might work as a replacement for these? I have alread ... (cont.)

DRWR DRESSER. 53090499 VR. 00-665-530. W07-102. C2-5. THESE ARE NUMBERS FOUND ON A LABEL IF THAT HELPS

I am still unable to find a replacement for HETTICH 2516 5.6 Can you please help? Thank you!

9 inches long

Hi all, I need to replace this hardware and roller or get a roller for this hardware. Can you assist? Thanks, Paul

I need the I don't know what you call it, but like a drawer runner. Also need the brown plastic piece at the end.

This is KCMA A161-1-1990 cabinetry. The plastic bracket at the back broke and there is no support for the drawer. Everything else is still good.

Any ideas where i could find this corner kitchen cabinet hinge?

Drawers and hardware from Wood Mode. Couple of spacers are cracked. Need 8 replacements

This piece is needed gonna replace them

I need to replace a rear bracket for my UNIGRASS 6600 sliding cupboard drawer. Can you tell me what I need, how to get it and how to install, please?

Hi, I need to replace the rear bracket on my sliding cupboard drawer. Can you tell me what bracket I need and how does it install? Any help is greatly appreciated! Thank you. Cindy E.

These are old KitchenMaid cabinets. Can you help find the part that holds the 2 doors together?

The plastic bracket for the right side drawer slide in my dresser has cracked. Can you please identify the replacement part and send me a quote for the replacement part?

Looking for replacement hinges for Crate and Barrel vanity.

I have a Project Source 15in x 30in wall cabinet. I need all the hardware to go with it (screws and hinges)

These drawer rail supports on my kitchen cabinets are breaking and I would like to find replacement brackets

This is an Aristokraft Pantry Cabinet with the middle shelves supported by piano hinges. The part I need is the plastic "Door Holder" used to keep the middle shelves in place.

Hi,I have 4 of these hinges. Two work properly but the other two are not true 90 degrees. Any help where to locate two more or a good substitution.Marked "Made in West Germany". A "1" on top of "05098". 3 5/8" l x 1 1/4" w at widest point and 3/4" deep.Leticia

Looking for a lazy susan hinge. Blum hinge AUSTRIA 70.655-01