Viewing all customer Discussions for:

Drawer & Cabinet

Customer is looking to purchase a Complete Drawer Track Set that he purchased a few years ago that is featured in this video. The Product Code is mentioned as being 32-063 however when searched, it no longer pulls up any parts. Was this kit discontinued? If so, are we able to put together an order ... (cont.)

Hi, I need to replace the plastic drawer guide on a couple of drawers . The part is marked Reiss Mfg. Corp N.Y.C. R-26 Pat. 2857233. I need 3 replacements. Could you please inform me if the part is available and place the order for me?

I am looking for a replacement Merilkat side drawe slide with the L shaped end. Do you know where I can find one?

Hinges are for my cabinets on a 1989 Sea Ray Sundancer 268 MSAS ZD240 Are the markings on the hinge

I have htc 533 drawer slides and most of the soft close dampers are going out and pushing the drawer back out after closing. On the light grey housing it says "HC 12 8" that is the only marking on either part. I would like to find a replacement as it just simply snaps in. The dark grey piston is ult ... (cont.)

Hello, I am swapping drawers from one cabinet to another using the existing hardware including these brackets, pictured, and 21 5/8" slides. The slides are mounted to the cabinet using these two brackets on each side (one in front and one in the back). Using these brackets, the width is about a 1/4" ... (cont.)

Please let me know if you need a better quality photo. I am in need of the part.

Drawers pull out and will not stop. Plastic part on back of drawer does not look broken. What is the part I need to stop the drawer from pulling out for wood center drawer glide. Thank you

Drawer guide

Bracket is 2"deep, slide in slot is 7/8"wide, back mounting is 2" long x 1 1/4" wide The lower lip keeps breaking out and the drawer drops. See pictures attached. Thank you for your help! JPG

I need several of these hinges and cannot find any identifying information on them. Can you help?

Hi -- I have a ~20 year old dresser and the drawers fall down when you pull them out. The plastic pieces seem beat up/broken and the tracks on the bottom of the drawers are also bent/blown out. We bought the dresser used from someone so we don't have a clue whether this has always been an issue or s ... (cont.)

I'm looking for this style of drawer guide(see picture). The opening where the track runs matches your Product Code: 32-088. Would this be a replacement for mine? I do like the style I have because it offers more support under the drawer and on to the track. Please advise. Thank youVictor ... (cont.)

kitchen cabinet door hinge, please hep!!! Germany 85HP soft close function.

Hi, all the cabinets in my kitchen use the same hinge, but it seems none of the ones at Home Depot or Lowe's work. They all make my cabinet sit with a big gap between the door and the face, due to the inner lip I think? Would love some help finding the right hinge.

There is no current hardware on this old tv armoire. The drawers fall out at about 1'. Do you have a part that would work on these old wooden drawers to allow them to be fully opened without falling? The measurements are:on drawer: 2" across where metal piece is attached groove is 11/16" w ... (cont.)

The opening size is 1.2 inches wide. Total width is about 2.45wide Total height is 1.9 inches height of bottom openingis .32 inches, the square area where the wood rail is .3inches high by about 1.2 inches wide. It about .52 inches thick at thickest part

The KV Metal bar that slides into rear socket is approximately 1 1/8" Rear track socket is approximately 2 1/2" long

Latches for kitchen cabinet door. spring tension for self-closing. brand name unknown.

I am looking for replacement cabinet hinges that fit flush like the Grass 830 style.