Viewing all customer Discussions for:

Drawer & Cabinet

We are unable to locate part numbers or the make of the cabinets. The piece we need is approximately 1 and 3/4 inches long. The plastic piece supports the cabinet glide. If you have this piece we would like to order 4 of them.

I have a 21.75" drawer with Unigrass 6600 slides and I need to replace the slides and the accompanying cabinet rails. The cabinet depth is 23.5". Please recommend what replacements I need. The existing cabinets have a plastic rear Mount extension bracket. You can see the rollers on the existing ... (cont.)

I'm currently looking for a replacement part for this hanging bracket for my kitchen drawer and was wondering if the product number 32-025 it close enough to use as a substitute.

Looking for inside pull out shelf latch.

The bracket has two posts in the back. Does not need screws.

Part number on holder H-1041 No manufacturer name on part Need 3 sets

My kitchen cabinets were built in 1980 and are custom plywood. The drawers are heavy by themselves. They all have a monorail drawer slide. What is the weight rating for your monorail slides? I would rather replace them with a ball-bearing center slide, but it might be easier to just replace the mon ... (cont.)

Do you happen to know if you guys carry this piece I know the photos aren't the best, but I need two of them. I cannot find them anywhere :(Outlined the only single marking on it which is a "2" let me know if you need measurements I hope this does it lolThank you!

Hi! Hope you are doing well. We bought a bathroom vanity that came with a drawer. However the sliders fell apart when trying to separate for assembly. We can't get a replacement part from the manufacturer and don't know what type of replacement slider to buy. Can you please help? Any direction ... (cont.)

Just wanted to say thanks much,the brackets arrived today and are a great fit! The discussion Q&A thread was very helpful. I installed immediately.

I need one drawer glide with a 1 3/16 by 5/16 glide opening. I believe your #32-118 would be a good replacement. How do I order it or where can I buy it?

Need new bracket Thank you Joe

Looking for a broken bracket that holds the drawer slide in the cabinet IIts the dark yellow piece mounted on back of cabinet the

Help identify push to open drawer slides

I have a kitchen full of Mepla European style cabinet hinges. The door side of the hinge reads: 674.229.53.00 Made in Austria The cabinet side of the hinge reads: 346.290.51.03 Made in W. Germany The house was built in 1988 and the hinge says Made in W. Germany so I suspect they are 32yrs old. T ... (cont.)

This drawer slider has lost the retainer that holds the wheel in place.This is the slider fastened to the wall on the right side of the drawer. It is approximately 20 3/4 ". I saw one on the website that says 21 5/8". Is that the size I need?

I've been searching for replacements of these obsolete self-closing, kitchen cabinet, hinges for ages. Ideally with the same number of holes, to avoid drilling new ones. The hinges don't show a manufacturer name, but a search on the patent number suggests they're Amerock: U.S. PAT. 3,613,151 OTH ... (cont.)

Looking for these drawer guides - can you help?

Would this system work to replace the old metal slide and wooden track system shown in the attached photos? The width of the drawer is about 24" and 15" depth. I wasn't sure if that would be too big of a drawer for this type of system.