Viewing all customer Discussions for:

Drawer & Cabinet

Hi! Hope you are doing well. We bought a bathroom vanity that came with a drawer. However the sliders fell apart when trying to separate for assembly. We can't get a replacement part from the manufacturer and don't know what type of replacement slider to buy. Can you please help? Any direction ... (cont.)

Just wanted to say thanks much,the brackets arrived today and are a great fit! The discussion Q&A thread was very helpful. I installed immediately.

I need one drawer glide with a 1 3/16 by 5/16 glide opening. I believe your #32-118 would be a good replacement. How do I order it or where can I buy it?

Need new bracket Thank you Joe

Looking for a broken bracket that holds the drawer slide in the cabinet IIts the dark yellow piece mounted on back of cabinet the

Help identify push to open drawer slides

I have a kitchen full of Mepla European style cabinet hinges. The door side of the hinge reads: 674.229.53.00 Made in Austria The cabinet side of the hinge reads: 346.290.51.03 Made in W. Germany The house was built in 1988 and the hinge says Made in W. Germany so I suspect they are 32yrs old. T ... (cont.)

This drawer slider has lost the retainer that holds the wheel in place.This is the slider fastened to the wall on the right side of the drawer. It is approximately 20 3/4 ". I saw one on the website that says 21 5/8". Is that the size I need?

I've been searching for replacements of these obsolete self-closing, kitchen cabinet, hinges for ages. Ideally with the same number of holes, to avoid drilling new ones. The hinges don't show a manufacturer name, but a search on the patent number suggests they're Amerock: U.S. PAT. 3,613,151 OTH ... (cont.)

Looking for these drawer guides - can you help?

Would this system work to replace the old metal slide and wooden track system shown in the attached photos? The width of the drawer is about 24" and 15" depth. I wasn't sure if that would be too big of a drawer for this type of system.

I have a custom cabinet and the back bracket for the drawer mount broke. Is there a replacement part? Picture below? Thank you for any help. Bryan

Hi, Can you identify this Blum hinge (from 1990s) and is there a form fit function replacement? Thanks!

Trying to find replacement parts or start over on a broken shelf.

Various parts numbers include: 611 243.01.92; 697.043.59.00; 598.243.59.00

I want to update the bathroom cabinet hardware to brushed nickel or polished chrome (not too picky) but they have these hinges and I'm having difficulty finding a match. Any suggestions?

Your site shows several previous searches for this part number. As shown in the fifth photo the center hole for the hinge is 1-3/8" (35 cm) in diameter. The two holes for the screws are 2-1/32" (5.15 cm) apart. The overlay is 1-3/8" These cabinets were installed in 2002.

Purchased 32-223 drawer slides and they were an inch shorter than the ones I replaced. Do they come in a longer size. The one on the drawer were yours. The one inside was the broken one 1" longer

We are looking for hinges to replace broken hinges that came on our Canaccabinets in 2003. They are stamped with the Canac logo and phone number but it appears that Canac is no longer in business. The hinges are also stamped with the Ferrari made in Italy logo. On the back of the hinge the number ... (cont.)